Phase I study of Datelliptium chloride, hydrochloride given by 24-h continuous intravenous infusion
Abstract:
Datelliptium chloride, hydrochloride (SR 95 156B, NSC 626718X, DHE) was studied in a phase I trial of escalating doses given on a single 24-h continuous intravenous infusion schedule. Doses were escalated from 40 to 500 mg/m2 in 19 patients who received a total of 24 courses. Courses were repeated after a minimal interval of 3 weeks. Local venous toxicity occurred at low doses (less than or equal to 100 mg/m2) and was circumvented by the use of a central venous access for higher doses. Other clinical adverse events occurred (greater than or equal to 330 mg/m2), including moderate nausea and vomiting, mild diarrhea, dry mouth, neuropsychiatric manifestations, and fatigue. All of these side effects were reversible and none was dose-limiting. The dose-limiting toxicity was related to hepatic laboratory-test abnormalities in the form of reversible elevations of levels of serum bilirubin and liver enzymes at doses of greater than or equal to 330 mg/m2. The maximum tolerated dose for this schedule is 500 mg/m2. Hematologic toxicity was minimal and non-dose-limiting. Neither drug-related deaths nor objective complete or partial responses were observed. However, a minor response and a long-term disease stabilization were obtained.
More Related Videos
08:44Continuous IV Infusion is the Choice Treatment Route for Arginine-vasopressin Receptor Blocker Conivaptan in Mice to Study Stroke-evoked Brain Edema
Published on: September 1, 2016
07:28Studying Metabolic Brain Connectivity Using 2-Deoxy-2-[18F]Fluoro-D-Glucose Dynamic Positron Emission Tomography at the Single-subject Level
Published on: January 24, 2025
Related Concept Videos
One-Compartment Model: IV Infusion
The one-compartment model for IV infusion uses mathematical equations to describe the rate of change in drug quantity in the body. At steady-state or infusion equilibrium, the drug input...
Drug Accumulation During Multiple Dosing: Intermittent IV Infusions
Determination of Multiple Dosing Parameters: Steady-State, Minimum and Maximum Concentrations
Determination of Multiple Dosing Parameters: Loading and Maintenance Doses
IV Infusion to Oral Dosing: Conversion Methods
Imaging Studies III: Computed Tomography
