ATP bioluminescence assay for estimation of microbial populations of fresh-cut melon

Estimation of microbial numbers in foods by conventional microbiological techniques takes days, so there is a need for faster methods that can give results in minutes. Research was undertaken to investigate the use of bioluminescent ATP determination and a firefly luciferase assay to estimate the initial population of aerobic mesophilic bacteria on fresh-cut melons immediately after preparation and during storage at 5 or 15 degrees C for up to 12 days. Populations of aerobic mesophilic bacteria on fresh-cut cantaloupe prepared immediately from unsanitized whole melons averaged 3.42 log CFU/g, corresponding to an ATP value of 5.40 log fg/g. Populations for fresh-cut honeydew prepared from unsanitized whole melon averaged 1.97 log CFU/g, corresponding an ATP value of 3.94 log fg/g. Fresh-cut pieces prepared from cantaloupe or honeydew melons sanitized with either chlorine (200 ppm free chlorine) or hydrogen peroxide (2.5%) had similar ATP values: 3.1 log fg/g (corresponding to bacterial counts 1.7 log CFU/g) for cantaloupes and 2.6 log fg/g (corresponding to bacterial counts of 0.48 CFU/g) for fresh-cut honeydew. Positive linear correlations for ATP concentrations and microbial populations were found for fresh-cut cantaloupe (R2 = 0.99) and honeydew R2 = 0.95) during storage at 5 degrees C for up to 12 days. ATP values in fresh-cut melons inoculated with either aerobic mesophilic bacteria or yeast and mold were significantly higher (P < 0.05) than control values and parallel total plate counts on plate count agar. Results of this study indicate that the bioluminescent ATP assay can be used to monitor total microbial populations on fresh-cut melon after preparation and during storage for quality control purposes to establish specific sell-by or consume-by dates.