Synthesis of chiral self-assembling rhombs and their characterization in solution, in the gas phase, and at the

Kyung Seok Jeong1, Sun Young Kim, Ueon-Sang Shin

  • 1Department of Chemistry and Division of Molecular Engineering and Chemistry, Korea University, Seoul, 136-701, Korea.

Related Concept Videos

Solution Formation02:16

Solution Formation

There is no one solvent that can dissolve every type of solute. Some substances that readily dissolve in a certain solvent might be insoluble in a different solvent. A simple way to predict which substances dissolve in which solvent is the phrase "like dissolves like". This means that polar substances, such as salt and sugar, dissolve in a polar substance like water. In contrast, non-polar substances are more soluble in non-polar solvents such as carbon tetrachloride.
This selective solubility...
Recrystallization: Solid–Solution Equilibria01:10

Recrystallization: Solid–Solution Equilibria

Recrystallization is a purification technique used to separate impurities from solid compounds. In this technique, no chemical reactions occur. Instead, it exploits physical properties only, specifically, the solubility differences between the desired compound and impurities, either at a single temperature or at different temperatures, and under other selected conditions. The solid-solution equilibrium (solubility equilibrium) of each component in the solution represents a binary phase...
Ideal Solutions or Mixtures01:20

Ideal Solutions or Mixtures

From a molecular perspective, an ideal solution is one in which the intermolecular interactions between unlike molecules are, on average, the same as those between like molecules. This is the case for ideal gas mixtures, where the molecules are far apart and do not interact with each other. However, for condensed phases like liquids or solids, the molecules are close together and interact with each other. In an ideal solution, the molecules of different species are so similar to each other that...
Two Components: Liquid–Liquid Systems01:27

Two Components: Liquid–Liquid Systems

A pressure-composition phase diagram explicitly describes the behavior of an ideal solution of two volatile liquids under varying pressures and compositions. A pressure-composition diagram has two main curves. The bubble point curve represents the plot of pressure versus liquid mole fraction. It indicates the pressure at which the first bubble of vapor forms from the liquid phase as the system pressure decreases.The dew point curve is the pressure versus vapor mole fraction. It indicates the...
Nonideal Two-Component Liquid Solutions01:29

Nonideal Two-Component Liquid Solutions

Nonideal liquid solutions, also known as real solutions, do not strictly follow Raoult's law. Raoult's law is a rule of thumb in physical chemistry. However, not all mixtures adhere to this law due to varying molecular interactions. For example, in an acetone/chloroform solution, the individual vapor pressures of the components are lower than expected, resulting in a total vapor pressure below that predicted by Raoult's law, causing a negative deviation.On the other hand, in an ethanol/water...
Liquid–Solid Solutions01:29

Liquid–Solid Solutions

The process of a solid dissolving in a liquid to form a solution is governed by the solubility limit, which is the maximum amount of the solid substance, or solute, that can be dissolved in a specific volume of the liquid or solvent. As the solute dissolves, it reaches a point where no more solute can be dissolved at a given temperature - this is known as the saturation point. However, if further solute is added and it manages to dissolve, the solution becomes supersaturated. Supersaturated...