Related Experiment Video

Updated: Aug 14, 2026

Resonance Raman Spectroscopy of Extreme Nanowires and Other 1D Systems
07:44

Resonance Raman Spectroscopy of Extreme Nanowires and Other 1D Systems

Published on: April 28, 2016

Four-point resistance of individual single-wall carbon nanotubes

B Gao1, Y F Chen, M S Fuhrer

  • 1Laboratoire Pierre Aigrain, Ecole Normale Supérieure, 75231 Paris 05, France.

Physical Review Letters
|December 31, 2005
PubMed

More Related Videos

Fabrication of Low Temperature Carbon Nanotube Vertical Interconnects Compatible with Semiconductor Technology09:20

Fabrication of Low Temperature Carbon Nanotube Vertical Interconnects Compatible with Semiconductor Technology

Published on: December 7, 2015

Facile Preparation of Internally Self-assembled Lipid Particles Stabilized by Carbon Nanotubes09:47

Facile Preparation of Internally Self-assembled Lipid Particles Stabilized by Carbon Nanotubes

Published on: February 19, 2016

Related Concept Videos

Resistance01:19

Resistance

When a current moves through any conductor, the conductor causes some level of difficulty for the current to flow. The measure of that difficulty is known as the resistance of the material and is represented by R. Every material has its own resistance. In the case of conductors, heat is emitted whenever a current passes through them. Resistance depends on the resistivity of the material. Resistivity is a characteristic of the material used to fabricate electrical components, whereas the...
Non-ohmic Devices00:51

Non-ohmic Devices

In most substances, the current flow is proportional to the voltage applied to it. A simple relationship between the values of current, voltage, and resistance is known as Ohm's law. Nonohmic devices do not exhibit a linear relationship between voltage and current. One such device is the semiconducting circuit element known as a diode. A diode is a circuit device that allows current flow in only one direction.
Consider a simple circuit consisting of a battery, a diode, and a resistor. A diode...
Resistivity01:22

Resistivity

When a voltage is applied to a conductor, an electrical field is generated, and charges in the conductor feel the force due to the electrical field. The current density that results depends on the electrical field and the properties of the material. In some materials, including metals at a given temperature, the current density is approximately proportional to the electrical field. In these cases, the current density can be modeled as:
Resistance and Conductance01:25

Resistance and Conductance

A conductor's DC resistance at a given temperature is influenced by its resistivity, length, and cross-sectional area. Resistivity is an inherent property of the conductor material, with annealed copper serving as the international standard for measurement. For instance, the resistivity of hard-drawn aluminum at 20 degrees Celsius is 61% of the standard conductivity of annealed copper.
Various factors impact the resistance of a conductor. Spiraling in stranded conductors increases their length...
Resistors In Parallel01:23

Resistors In Parallel

Resistors are in parallel when one end of all the resistors are connected to a continuous wire of negligible resistance and the other end of all the resistors are also connected to one another through a continuous wire of negligible resistance. In the case of a parallel configuration, the potential drop across each resistor is the same. Current through each resistor can be found using Ohm’s law, I = V/R, where the voltage is constant across each resistor. The sum of the individual currents...