Global fluid phase equilibria and critical phenomena of selected mixtures using the crossover soft-SAFT equation

Fèlix Llovell1, Lourdes F Vega

  • 1Institut de Ciència de Materials de Barcelona, (ICMAB-CSIC), Consejo Superior de Investigaciones Científicas, Campus de la U.A.B., Bellaterra, 08193 Barcelona, Spain.

Related Concept Videos

Two Components: Liquid–Liquid Systems01:27

Two Components: Liquid–Liquid Systems

A pressure-composition phase diagram explicitly describes the behavior of an ideal solution of two volatile liquids under varying pressures and compositions. A pressure-composition diagram has two main curves. The bubble point curve represents the plot of pressure versus liquid mole fraction. It indicates the pressure at which the first bubble of vapor forms from the liquid phase as the system pressure decreases.The dew point curve is the pressure versus vapor mole fraction. It indicates the...
Phase Diagrams02:39

Phase Diagrams

A phase diagram combines plots of pressure versus temperature for the liquid-gas, solid-liquid, and solid-gas phase-transition equilibria of a substance. These diagrams indicate the physical states that exist under specific conditions of pressure and temperature and also provide the pressure dependence of the phase-transition temperatures (melting points, sublimation points, boiling points). Regions or areas labeled solid, liquid, and gas represent single phases, while lines or curves represent...
Phase Transitions: Sublimation and Deposition02:33

Phase Transitions: Sublimation and Deposition

Some solids can transition directly into the gaseous state, bypassing the liquid state, via a process known as sublimation. At room temperature and standard pressure, a piece of dry ice (solid CO2) sublimes, appearing to gradually disappear without ever forming any liquid. Snow and ice sublimate at temperatures below the melting point of water, a slow process that may be accelerated by winds and the reduced atmospheric pressures at high altitudes. When solid iodine is warmed, the solid sublimes...
Ideal Solutions or Mixtures01:20

Ideal Solutions or Mixtures

From a molecular perspective, an ideal solution is one in which the intermolecular interactions between unlike molecules are, on average, the same as those between like molecules. This is the case for ideal gas mixtures, where the molecules are far apart and do not interact with each other. However, for condensed phases like liquids or solids, the molecules are close together and interact with each other. In an ideal solution, the molecules of different species are so similar to each other that...
Solid–Solid Solutions01:24

Solid–Solid Solutions

The temperature-composition phase diagram of two solids, A and B, which are immiscible in the solid phase but form miscible liquids, shows that when the temperature is low, these two exist as separate, pure solids (A and B). As the temperature increases, they transition into a single-phase liquid solution where A and B coexist. Moving from point a1 to a2 in the phase diagram, the composition changes such that solid B begins to separate from the solution, enriching the remaining liquid with A.
Chemical and Solubility Equilibria02:21

Chemical and Solubility Equilibria

The free energy change associated with dissolving a solute in a liter of solvent is called the free energy of a solution, ΔGsolution. The overall ΔGsolution is expressed as the balance of ΔGinteraction against the always-favorable free-energy of mixing, ΔGmixing. Solution formation is favorable if  ΔGsolution is less than zero, whereas it is unfavorable if ΔGsolution is greater than zero. In short, for a solution to form and complete dissolution to take place, the Gibbs energy change must be...