Verification of Onsager's reciprocal relations for evaporation and condensation using non-equilibrium molecular

J Xu1, S Kjelstrup, D Bedeaux

  • 1Department of Chemistry, Faculty of Natural Science and Technology, Norwegian University of Science and Technology, Trondheim 7491, Norway.

Related Concept Videos

Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
Distillation: Vapor–Liquid Equilibria01:01

Distillation: Vapor–Liquid Equilibria

Distillation is a separation technique that takes advantage of the boiling point properties of disparate elements in a mixture. To perform distillation, we begin by heating a miscible mixture of two liquids with a significant difference in boiling points (at least 20°C). As the solution heats up and reaches the bubble point of the more volatile component, some molecules of the more volatile component transition into the gas phase and travel upward into the condenser, which is a glass tube with...
Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation04:01

Real Gases: Effects of Intermolecular Forces and Molecular Volume Deriving Van der Waals Equation

Thus far, the ideal gas law, PV = nRT, has been applied to a variety of different types of problems, ranging from reaction stoichiometry and empirical and molecular formula problems to determining the density and molar mass of a gas. However, the behavior of a gas is often non-ideal, meaning that the observed relationships between its pressure, volume, and temperature are not accurately described by the gas laws.
Variables and Equations of State01:27

Variables and Equations of State

The physical state of a pure substance can be defined by certain state variables such as volume (V), pressure (p), temperature (T), and amount of substance (n). When two gases are separated by a movable wall, the gas with the higher pressure naturally compresses the gas with the lower pressure. This causes the high-pressure gas to expand and the low-pressure gas to compress until both gases achieve mechanical equilibrium. At this point, their pressures equalize, and the movement of the wall...
Adiabatic Processes for an Ideal Gas01:18

Adiabatic Processes for an Ideal Gas

When an ideal gas is compressed adiabatically, that is, without adding heat, work is done on it, and its temperature increases. In an adiabatic expansion, the gas does work, and its temperature drops. Adiabatic compressions actually occur in the cylinders of a car, where the compressions of the gas-air mixture take place so quickly that there is no time for the mixture to exchange heat with its environment. Nevertheless, because work is done on the mixture during the compression, its...
Vapor Pressure of Fluid01:28

Vapor Pressure of Fluid

The vapor pressure of a fluid is a crucial concept in fluid mechanics, influencing phenomena such as boiling and cavitation. Vapor pressure refers to the pressure exerted by a vapor at a state of thermodynamic equilibrium with its corresponding liquid phase at a specific temperature. It represents the tendency of molecules to escape from the fluid surface into the vapor phase.
When a liquid is placed in a closed container with a small air space, and the space is evacuated, vapor molecules will...