Load-independent index of diastolic filling: model-based derivation with in vivo validation in control and diastolic
Leonid Shmuylovich1, Sándor J Kovács
1Cardiovascular Biophysics Laboratory, Washington University School of Medicine, St. Louis, Missouri, USA.
Abstract:
Maximum elastance is an experimentally validated, load-independent systolic function index stemming from the time-varying elastance paradigm that decoupled extrinsic load from (intrinsic) contractility. Although Doppler echocardiography is the preferred method of diastolic function (DF) assessment, all echo-derived indexes are load dependent, and no invasive or noninvasive load-independent index of filling (LIIF) exists. In this study, we derived and experimentally validated a LIIF. We used a kinematic filling paradigm (the parameterized diastolic filling formalism) to predict and derive the (dimensionless) dynamic diastolic efficiency M, defined by the slope of the peak driving force [maximum driving force (kx(o)) proportional, variant peak atrioventricular (AV) gradient] to maximum viscoelastic resistive force [peak resistive force (cE(peak))] relation. To validate load independence, we analyzed E-waves recorded while load was varied via tilt table (head up, horizontal, and head down) in 16 healthy volunteers. For the group, linear regression of E-wave derived kx(o) vs. cE(peak) yielded kx(o) = M (cE(peak)) + B, r2 = 0.98; where M = 1.27 +/- 0.09 and B = 5.69 +/- 1.70. Effects of diastolic dysfunction (DD) on M were assessed by analysis of preexisting simultaneous cath-echo data in six DD vs. five control subjects. Average M for the DD group (M = 0.98 +/- 0.07) was significantly lower than controls (M = 1.17 +/- 0.05, P < 0.001). We conclude that M is a LIIF because it uncouples intrinsic DF (i.e., the pressure-flow relation) from extrinsic load (left ventricular end-diastolic pressure). Larger M values imply better DF in that increasing AV pressure gradient results in relatively smaller increases in peak resistive losses (cE(peak)). Conversely, lower M implies that increasing AV gradient leads to larger increases in resistive losses. Further prospective validation characterizing M in well-defined pathological states is warranted.
More Related Videos
08:57Pulsed Wave Doppler Assessment of Diastolic Dysfunction in the ZSF-1 Rat Model of Pulmonary Hypertension Due to Left Heart Disease
Published on: May 22, 2026
07:49A Pacing-Controlled Procedure for the Assessment of Heart Rate-Dependent Diastolic Functions in Murine Heart Failure Models
Published on: July 21, 2023
