Retained nitrate, hydrated sulfates, and carbonaceous mass in federal reference method fine particulate matter for...

Material balance of fine particulate matter (PM2.5) measured with the Federal Reference Method (FRM) is developed for one rural and five urban locations in the eastern half of the United States using routine Speciation Trends Network (STN) and FRM chemical measurements and thermodynamic models. The Aerosol Inorganics Model is used to estimate retained particle bound water, and an ammonium nitrate evaporation model is used to estimate nitrate concentrations retained on the Teflon-membrane filter of the FRM. To address large uncertainties in carbonaceous mass calculated from STN carbon measurements, retained carbonaceous mass is derived by material balance between PM2.5 FRM mass and estimates of its non-carbon constituents. The resulting sulfate, adjusted nitrate, derived water, inferred carbonaceous material balance approach (SANDWICH) is compared with reconstructed fine mass (RCFM) using the Interagency Monitoring of Protected Visual Environments monitoring program equation. For this study, the SANDWICH method resulted in approximately 21-27% higher sulfate mass and approximately 24-85% lower nitrate mass. The combined mass associated with sulfates and nitrates, however, are well within +/- 10% of the proportion derived using the more traditional RCFM method. The discrepancies between SANDWICH and measurement-derived carbonaceous mass vary from -21% to +56% on an annual basis and are attributed in part to urban-rural source influences and uncertainties in estimating FRM-retained carbonaceous mass.