Studies of CO adsorption on Pt(100), Pt(410), and Pt(110) surfaces using density functional theory

Adsorption of CO on Pt(100), Pt(410), and Pt(110) surfaces has been investigated by density functional theory (DFT) method (periodic DMol(3)) with full geometry optimization and without symmetry restriction. Adsorption energies, structures, and vibrational frequencies of CO on these surfaces are studied by considering multiple possible adsorption sites and comparing them with the experimental data. The same site preference as inferred experiments is obtained for all the surfaces. For Pt(100), CO adsorbs at the bridge site at low coverage, but the atop site becomes most favorable for the c(2 x 2) structure at 1/2 monolayer. For Pt(410) (stepped surface with (100) terrace and (110) step), CO adsorbs preferentially at the atop site on the step edge at 1/4 monolayer, but CO populates also at other atop and bridge sites on the (100) terrace at 1/2 monolayer. The multiple possible adsorption sites probably correspond to the multiple states in the temperature-programmed desorption spectra for CO desorption. For Pt(110), CO adsorbs preferentially at the atop site on the edge for both the reconstructed (1 x 2) and the un-reconstructed (1 x 1) surfaces. When adjacent sites along the edge row begin to be occupied, the CO molecules tilt alternately by ca. 20 degrees from the surface normal in opposite directions for both the (1 x 2) and (1 x 1) surfaces.