Adsorption of cyanuric acid on activated carbon from aqueous solution: effect of carbon surface modification and...

The performance of a conventional and two surface-modified activated carbon samples was investigated for the sorption of cyanuric acid from aqueous solution by varying the process parameters such as initial concentration, pH, temperature, dose of adsorbents, and agitation time. The modified carbon samples obtained by acid and ammonia treatment of the conventional sample had a higher BET surface area (989 and 1010 m2 g-1, respectively) and higher specific mesopore surface area (27.36 and 33.21 m2 g-1, respectively) compared to the untreated material (820 and 18.25 m2 g-1). The solute removal was found to be favored at lower solute concentration, increased agitation time, increased adsorbent dose, and lower temperature. The modified adsorbents outperformed the conventional activated carbon for sorption of cyanuric acid especially at higher pH (>7.5) and with increasing temperature. The Freundlich model appears to fit the isotherm data better than the Langmuir model. The thermodynamic parameters (DeltaG degrees ads, DeltaH degrees, and DeltaS degrees) were evaluated showing that the sorption process was thermodynamically favorable, spontaneous, and exothermic. The findings can be used for predictive modeling for analysis and design adsorption systems for removal of cyanuric acid and other polar atrazine degradation products from environmental aqueous samples.