Use of flow cytometry for analysis of phage-mediated killing of Enterobacter aerogenes

In this study, the use of flow cytometry to analyze phage-mediated killing of Enterobacter aerogenes under varying conditions of temperature and nutrient availability was assessed. Bacteriophage UZ1, specific for an E. aerogenes strain, was applied at a multiplicity of infection (MOI) of 1 and 1000 to a Teflon surface, artificially infected with its host at a level of 4.5 log cells. After incubation for 20 h, bacteriophages were quantified using the soft agar layer method. For the quantification of bacterial cells, plate counting and flow cytometric analysis of live/dead stained cells were performed in parallel. At an MOI of 1, phage treatment was successful only after incubation under nutrient-rich conditions at 37 degrees C: E. aerogenes cells were not detected and a tenfold increase in phage UZ1 was observed. At a MOI of 1000, no E. aerogenes cells could be cultured after incubation at 37 and 4 degrees C. However, flow cytometric analysis revealed that lysis did not occur at 4 degrees C but was achieved during subsequent plate culture. In conclusion, the use of flow cytometry enabled identification of culture-based bias during plate culture. The flow cytometric assay used in this study proved to be rapid, as this culture-independent method does not require lengthy incubation periods post-sampling. The bacteriophage-mediated killing of E. aerogenes cells on Teflon surfaces indicated that disinfection of E. aerogenes with bacteriophage UZ1 can be successful when high MOIs are achieved, while at low multiplicities of infection conditions favorable for phage replication are required.