[Pattern-induced after effects caused by an on-screen workstation]

G Kluxen1

  • 1Augenbelegabteilung Krankenhaus Wermelskirchen GmbH, Bruckenweg 1, 42929 Wermelskirchen. gkluxen@t-online.de

Klinische Monatsblatter Fur Augenheilkunde
|August 24, 2006
PubMed

Related Concept Videos

Muscle Stimulation Frequency01:22

Muscle Stimulation Frequency

The contraction strength of muscles is regulated by motor neurons, which modulate the frequency of action potentials dispatched to the motor units based on the body's requirements. This process of varying the muscle stimulation frequency allows muscles to contract with a force that is precisely tailored to the needs of the moment, whether lifting a feather or a heavy box.
Wave summation
At low firing rates, motor neurons induce individual twitch contractions in muscle fibers. These twitches...
First Pass Effect01:12

First Pass Effect

Presystemic elimination, or the first-pass effect, is the metabolism of drugs that reduces their effective concentration at the site of action. Apart from the first-pass effect, the systemic bioavailability of the drug is also reduced by other factors, including incomplete absorption or chemical degradation of drugs.
Depending on the route of administration, drugs can be metabolized in the liver, intestine, lungs, and vasculature. Orally administered drugs are first absorbed through the...
Effects of Creep01:25

Effects of Creep

Creep in concrete, the gradual deformation under prolonged stress, significantly impacts the integrity of structures. For reinforced concrete beams, it can be a vital design consideration, as it increases deflection, sometimes necessitating additional design measures. In columns, especially slender ones under eccentric loads, creep can cause buckling, compromising their stability. However, creep can be beneficial in indeterminate structures by mitigating stresses that arise from shrinkage,...
Time-Domain Interpretation of PD Control01:07

Time-Domain Interpretation of PD Control

Proportional-Derivative (PD) control is a widely used control method in various engineering systems to enhance stability and performance. In a system with only proportional control, common issues include high maximum overshoot and oscillation, observed in both the error signal and its rate of change. This behavior can be divided into three distinct phases: initial overshoot, subsequent undershoot, and gradual stabilization.
Consider the example of control of motor torque. Initially, a positive...