Related Experiment Video
Updated: Jul 19, 2026
Low-cost Custom Fabrication and Mode-locked Operation of an All-normal-dispersion Femtosecond Fiber Laser for Multiphoton Microscopy
Published on: November 22, 2019
110 W double-ended ytterbium-doped fiber superfluorescent source with M2 = 1.6
P Wang1, J K Sahu, W A Clarkson
1Optoelectronics Research Center, University of Southampton, Highfield, Southampton, SO17 1BJ, UK. puw@orc.soton.ac.uk
Abstract:
High-power operation of a broadband superfluorescent fiber source has been achieved via the process of amplified spontaneous emission (ASE) in a double-clad Yb-doped multimode-offset-core fiber by using a novel fiber-end termination geometry to suppress lasing. The fiber was cladding pumped by a high-power diode source at 976 nm and yielded a maximum ASE output of 63 and 47 W from the two ends of the fiber, respectively. The maximum combined ASE output was 110 W with slope efficiency with respect to launched pump power of up to 68%. The wavelength spectrum of the ASE source spanned the range from approximately 1032 to 1120 nm, and the bandwidth (FWHM) of the emission spectrum was 40 nm. The output beam was slightly multimode with a beam-quality factor (M2) of 1.6. The prospects for further improvement in performance are considered.
