[Analytical and on-site detection methods for chemical warfare agents]

Chemical warfare agents (CWAs) are fast acting and sometimes lethal, even at low levels, and can be classified into nerve gases, blister agents, choking agents, blood agents, vomit agents, tear gases, and incapacitating agents. As countermeasures against CWA terrorism, detection and identification are important. In crisis management, monitoring of CWAs in public places and security checks at territorial borders, big event venues, and executive facilities are performed for protection against terrorism. In consequence management, on-site detection by first responders and laboratory analysis after on-site sampling and transfer are performed for minimization of terrorism damage, leading to personal protection, initial investigation, and emergency lifesaving. In incident management, laboratory analysis is performed to provide evidence at court trials for the prevention of future crimes. Laboratory analysis consists of pretreatment of on-site and casualty samples and instrumental analysis using GC-MS. However, CWAs are easily degraded, and thus are difficult to detect. Instead, it is useful to detect their metabolites and degradation products using tert-butyldimethylsilyl derivatization GC-MS or direct LC-MS. Commercially available chemical detection equipment such as gas detection tubes and ion mobility spectrometers are used for on-site detection. We have evaluated the detection performance of such equipment and found that no equipment fulfills the required perfect performance of CWA detection sensitivity, accuracy, response time, return time, and operation. To overcome the drawbacks, we have adopted the monitoring tape method and counterflow introduction atmospheric pressure chemical ionization mass spectrometry and recommend the combination of commercial detection equipment and these new technologies for simultaneous, rapid detection of all CWAs.