Recoil effect of the ice hockey stick during a slap shot

A Villaseñor1, R A Turcotte, D J Pearsall

  • 1Department of Kinesiology and Physical Education, McGill University, Montréal, Québec, Canada.

Related Concept Videos

Impulse-Momentum Theorem00:49

Impulse-Momentum Theorem

The total change in the motion of an object is proportional to the total force vector acting on it and the time over which it acts. This product is called impulse, a vector quantity with the same direction as the total force acting on the object.
By writing Newton's second law of motion in terms of the momentum of an object and the external force acting on it, and simultaneously using the definition of the impulse vector, it can be shown that the total impulse on an object is equal to its net...
Impact Loading01:19

Impact Loading

Impact loading occurs when a moving object collides with a stationary structure, such as a rod with a uniform cross-sectional area fixed at one end. Under these conditions, the rod absorbs the kinetic energy from the striking object, leading to deformation and subsequent stress development. As the rod returns to its original position and reaches maximum stress, the absorbed energy, initially manifested as kinetic energy, transforms entirely into strain energy.
In cases of elastic deformation,...
Frictional Force01:07

Frictional Force

When a body is in motion, it encounters resistance because the body interacts with its surroundings. This resistance is known as friction, a common yet complex force whose behavior is still not completely understood. Friction opposes relative motion between systems in contact, but also allows us to move. Friction arises in part due to the roughness of surfaces in contact. For one object to move along a surface, it must rise to where the peaks of the surface can skip along the bottom of the...
Static and Kinetic Frictional Force01:05

Static and Kinetic Frictional Force

One of the simpler characteristics of sliding friction is that it is parallel to the contact surfaces between systems, and is always in a direction that opposes the motion or attempted motion of the systems relative to each other. If two systems are in contact and moving relative to one another, then the friction between them is called kinetic friction. For example, kinetic friction slows a hockey puck sliding on ice.
However, if two systems are in contact and are stationary relative to one...
Conservation of Linear Momentum for a System of Particles01:28

Conservation of Linear Momentum for a System of Particles

In the dynamic realm of billiards, a fascinating interplay of forces governs the motion of cue balls and stationary balls. When the cue ball collides with a stationary ball, linear momentum is exchanged. The cue ball imparts a fraction of its linear momentum to the stationary ball, causing the cue ball to decelerate while initiating the motion of the stationary ball.
The impulsive force at play during this interaction is of extremely short duration, rendering its impulse negligible. When...
Impulse01:13

Impulse

According to Newton’s second law of motion, the rate of change of the momentum of an object is the net external force acting on it. The total change in momentum between two timepoints thus depends on both the external force acting on it and the time over which it acts. Describing this mathematically, the total change of an object’s motion is proportional to the force vector and the time over which it is applied. This product is called impulse.
Additionally, it can be shown that the total...