Large Hadron Collider. Having a blast, wish you were here

The process of converting very light nuclei into heavier nuclei is also accompanied by the conversion of mass into large amounts of energy, a process called fusion. The principal source of energy in the sun is a net fusion reaction in which four hydrogen nuclei fuse and ultimately produce one helium nucleus and two positrons.
A helium nucleus has a mass that is 0.7% less than that of four hydrogen nuclei; this lost mass is converted into energy during the fusion. This reaction produces about...

According to Newton’s second law of motion, the rate of change of the momentum of an object is the net external force acting on it. The total change in momentum between two timepoints thus depends on both the external force acting on it and the time over which it acts. Describing this mathematically, the total change of an object’s motion is proportional to the force vector and the time over which it is applied. This product is called impulse.
Additionally, it can be shown that the total...

When two or more objects collide with each other, they can stick together to form one single composite object (after collision). The total mass of the object after the collision is the sum of the masses of the original objects, and it moves with a velocity dictated by the conservation of momentum. Although the system's total momentum remains constant, the kinetic energy decreases, and thus such a collision is an inelastic collision. Most of the collisions between objects in daily life are...

The internal combustion engine is a heat engine that uses the byproducts of combustion as the working fluid instead of using a heat transfer medium to transfer heat. The combustion is done in a way that produces high-pressure combustion products that can be expanded through a turbine or piston to create work. Internal combustion engines can again be categorized into three kinds: (1) spark ignition gasoline engines, most commonly used in automobiles, (2) compression ignition diesel engines that...

A rigid body subjected to three forces acting at three points is known as a three-force member. These forces must have concurrent lines of action, except for parallel forces, where the lines of action are parallel.
For example, consider a dumpster connected to a pin support at point A and a pin attached to a hydraulic cylinder at point B.

Machines are complex structures consisting of movable, pin-connected multi-force members that work together to transmit forces. One example of a machine is the cutting plier, which is used to cut wires by applying forces to its handles. When equal and opposite forces are exerted on the handles of the cutting plier, they cause the cutting edges to come together and apply equal and opposite reaction forces on the wire, which are greater than the applied forces.
A free-body diagram of the...