Related Experiment Video
Updated: Jul 15, 2026

Paradigms of Lower Extremity Electrical Stimulation Training After Spinal Cord Injury
Published on: February 1, 2018
Functional output improvement in FES cycling by means of forced smooth pedaling
Johann Szecsi1, Phillip Krause, Siegbert Krafczyk
1Center for Sensorimotor Research, Department of Neurology, Ludwig-Maximillians University, Munich, Germany. jszecsi@nefo.med.uni-muenchen.de
Purpose:
Investigation of the influence of forced smooth and normal (nonsmooth) pedaling on the functional output of outdoor functional neuromuscular electrical stimulation (FES)-propelled cycling of spinal cord-injured subjects.
Subjects:
Twelve subjects with complete spinal cord injury (T4-T12) and limited previous FES training.
Method:
Each subject participated in two separate outdoor sessions: once while pedaling a tricycle in a fixed gear, and a second time while free pedaling the same tricycle; both times with FES. Data on distance covered until exhaustion, cadence, and pedal forces were collected. Energy balance calculations led to evaluations of jerk loss and joint-related concentric/eccentric work.
Results:
First-trial and total session distances were 68 and 103% longer, respectively, in the forced smooth cycling session than in the free cycling session (P < 0.001). Significantly more additional crank work (accompanied by increased concentric work production) was generated in nonsteady cycling phases to overcome increased jerk losses during free than during fixed-gear pedaling. During fixed-gear pedaling, timing and joint location of muscle work generation were more similar to the cycling of able-bodied subjects than during freewheel pedaling, because most work was generated by knee extensors in the power phase during the former pedaling mode.
Conclusions:
The superiority of forced smooth cycling to free cycling, as regards functional output distance, is based on less energy expenditure (less jerk loss and muscle tension) and on more efficient production of energy (more efficient timing and joint location of work production). Some energetic mechanisms that are advantageous for fixed-gear cycling act predominantly in unsteady phases; others work continuously during all phases of cycling.
Related Concept Videos
Muscle Stimulation Frequency
Wave summation
At low firing rates, motor neurons induce individual twitch contractions in muscle fibers. These twitches...
Motor Unit Stimulation
The latent period of contraction marks the onset of excitation-contraction coupling, when the action potential propagates across the sarcolemma, preparing the muscle fibers for contraction. As the fibers enter the contraction phase, the...
Carnot Cycle and Efficiency
Exercise and Cardiac Output
Sustained exercise increases the muscles' oxygen demand, which can be met...
Cross-bridge Cycle
Efficiency of The Carnot Cycle
