Dependence of (35)Cl NQR on hydrogen bonding and temperature in dichlorophenol-aniline charge transfer complexes

D Ramananda1, K P Ramesh, J Uchil

  • 1Department of Materials Science, Mangalore University, Mangalagangothri-574 119, India. ramanandabak@rediffmail.com

Related Concept Videos

Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility02:34

Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility

Intermolecular forces are attractive forces that exist between molecules. They dictate several bulk properties, such as melting points, boiling points, and solubilities (miscibilities) of substances. Molar mass, molecular shape, and polarity affect the strength of different intermolecular forces, which influence the magnitude of physical properties across a family of molecules.
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
¹H NMR of Conformationally Flexible Molecules: Variable-Temperature NMR01:15

¹H NMR of Conformationally Flexible Molecules: Variable-Temperature NMR

The axial and equatorial protons in cyclohexane can be distinguished by performing a variable-temperature NMR experiment. In this process, except for one proton, the remaining eleven protons are replaced by deuterium. The deuterium substitution avoids the possible peak splitting caused by the spin-spin coupling between the adjacent protons. The remaining proton flips between the axial and equatorial positions.
IR Spectrum Peak Broadening: Hydrogen Bonding01:23

IR Spectrum Peak Broadening: Hydrogen Bonding

The vibrational frequency of a bond is directly proportional to its bond strength. As a result, stronger bonds vibrate at higher frequencies, while weaker bonds vibrate at lower frequencies. The stretching vibration of the strong O–H bond in alcohols and phenols (very dilute solution or gas phase) appears as a sharp peak at 3600–3650 cm−1.
However, the extent of hydrogen bonding influences the observed stretching frequency and band broadening. Intermolecular or intramolecular hydrogen bonding...
Intermolecular Forces03:13

Intermolecular Forces

Atoms and molecules interact through bonds (or forces): intramolecular and intermolecular. The forces are electrostatic as they arise from interactions (attractive or repulsive) between charged species (permanent, partial, or temporary charges) and exist with varying strengths between ions, polar, nonpolar, and neutral molecules. The different types of intermolecular forces are ion–dipole, dipole–dipole, hydrogen bonds, and dispersion; among these, dipole–dipole, hydrogen bonds, and dispersion...
¹H NMR of Conformationally Flexible Molecules: Temporal Resolution00:52

¹H NMR of Conformationally Flexible Molecules: Temporal Resolution

At room temperature, the chair conformer of cyclohexane undergoes rapid ring flipping between two equivalent chair conformers at a rate of approximately 105 times per second. These two chair conformers are in equilibrium. The rapid ring flipping results in the interconversion of the axial proton to an equatorial proton and an equatorial to the axial proton. Such interconversions are too rapid and cannot be detected on the NMR timescale. Hence, the NMR spectrometer cannot distinguish between the...
Acidity and Basicity of Alcohols and Phenols02:36

Acidity and Basicity of Alcohols and Phenols

Like water, alcohols are weak acids and bases. This is attributed to the polarization of the O–H bond making the hydrogen partially positive. Moreover, the electron pairs on the oxygen atom of alcohol make it both basic and nucleophilic. Protonation of an alcohol converts hydroxide, a poor leaving group, into water—a good one. The two acid–base equilibria corresponding to ethanol are depicted below.