Geothermal convection through oceanic crust and sediments in the Indian ocean

Science (New York, N.Y.)
|May 25, 1979
PubMed

Related Concept Videos

Primary Production01:06

Primary Production

The total amount of energy acquired by primary producers in an ecosystem is called gross primary production (GPP). However, of this energy, producers use some for metabolic processes, and some is lost as heat, decreasing the amount of energy available to the next trophic level. The remaining usable amount of energy is called the net primary productivity (NPP). In terrestrial ecosystems, NPP is driven by climate, while light penetration and nutrient availability drive NPP in aquatic ecosystems.
Heat Flow and Specific Heat01:12

Heat Flow and Specific Heat

Heat is a type of energy transfer that is caused by a temperature difference, and it can change the temperature of an object. Since heat is a form of energy, its SI unit is the joule (J). Another common unit of energy often used for heat is the calorie (cal), which is defined as the energy needed to change the temperature of 1 g of water by 1 °C, specifically between 14.5 °C and 15.5 °C, since the energy needed shows a slight temperature dependence. Another commonly used unit is the kilocalorie...
Mechanisms of Heat Transfer II01:20

Mechanisms of Heat Transfer II

In convection, thermal energy is carried by the large-scale flow of matter. Ocean currents and large-scale atmospheric circulation, which result from the buoyancy of warm air and water, transfer hot air from the tropics toward the poles and cold air from the poles toward the tropics. The Earth’s rotation interacts with those flows, causing the observed eastward flow of air in the temperate zones. Convection dominates heat transfer by air, and the amount of available space for the airflow...
Isothermal Processes01:21

Isothermal Processes

A thermodynamic process that occurs at constant temperature is called an isothermal process. Heat slowly flows into the system or out of the system to maintain thermal equilibrium. Processes involving phase changes like water evaporation into steam or freezing water into ice at a constant temperature are examples of Isothermal Processes.
An ideal gas can also undergo isothermal expansion or compression.
For example, consider 1 mole of an ideal gas inside an isolated cylinder at initial volume V...
Marine Microbial Ecology01:30

Marine Microbial Ecology

Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...
Deep Sea Microbial Ecology01:18

Deep Sea Microbial Ecology

The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches extending beyond...