Related Experiment Video

Updated: Jun 11, 2026

Sediment Core Extrusion Method at Millimeter Resolution Using a Calibrated, Threaded-rod
06:06

Sediment Core Extrusion Method at Millimeter Resolution Using a Calibrated, Threaded-rod

Published on: August 17, 2016

Aluminum-26 in pacific sediment: implications

J T Wasson, B Alder, H Oeschger

    Science (New York, N.Y.)
    |January 27, 1967
    PubMed

    More Related Videos

    Extraction of Organochlorine Pesticides from Plastic Pellets and Plastic Type Analysis10:12

    Extraction of Organochlorine Pesticides from Plastic Pellets and Plastic Type Analysis

    Published on: July 1, 2017

    Monitoring Pedogenic Inorganic Carbon Accumulation Due to Weathering of Amended Silicate Minerals in Agricultural Soils.07:32

    Monitoring Pedogenic Inorganic Carbon Accumulation Due to Weathering of Amended Silicate Minerals in Agricultural Soils.

    Published on: June 4, 2021

    Related Concept Videos

    Porosity and Absorption of Aggregate01:20

    Porosity and Absorption of Aggregate

    Aggregates contain pores of varying sizes; while some are completely enclosed within the particles, others open onto the surface, allowing water to penetrate. The porosity of aggregates is a major factor contributing to the overall porosity of concrete, given that aggregates constitute about three-quarters of concrete's volume.
    When all pores in an aggregate are filled with water, the aggregate is considered saturated and surface-dry. If left in dry air, water will evaporate until the aggregate...
    Deleterious Substances in Aggregate01:25

    Deleterious Substances in Aggregate

    Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
    Another type of impurity is clay and fine material that...
    Effect of Sea Water on Concrete01:22

    Effect of Sea Water on Concrete

    Concrete exposed to seawater can undergo degradation like the dissolution of ettringite and gypsum, increasing the material's porosity and decreasing its strength. In contrast, the crystallization of salts within the concrete's pores can cause expansion, particularly above the waterline where evaporation occurs. Nonetheless, this expansion only happens when seawater, enabled by the concrete's permeability, manages to infiltrate the structure.
    Concrete in areas between tide marks, which undergo...
    Marine Microbial Ecology01:30

    Marine Microbial Ecology

    Marine microbial ecosystems are shaped by distinct physicochemical limits, including high salinity, low nutrient availability, and fluctuating oxygen levels. These conditions favor smaller microbial cell sizes, which maximize their surface-to-volume ratio for efficient nutrient uptake.Microbial activity and community composition are closely linked to biogeochemical cycles, particularly in dynamic environments like estuaries, where halotolerant microbes thrive in response to variable salinity...
    Deep Sea Microbial Ecology01:18

    Deep Sea Microbial Ecology

    The deep ocean and its underlying sediments represent vast, largely unexplored microbial habitats that extend far beyond the sunlit photic zone. The photic (euphotic) zone typically spans the upper ~100–200 meters of pelagic waters in the open ocean, but its depth varies geographically and seasonally, where sufficient light supports photosynthetic life. Below this lies the deep sea, spanning roughly 1000–6000 meters (bathypelagic to abyssal zones), with deeper hadal trenches extending beyond...