Related Experiment Video

Updated: Jul 12, 2026

Flame Experiments at the Advanced Light Source: New Insights into Soot Formation Processes
10:04

Flame Experiments at the Advanced Light Source: New Insights into Soot Formation Processes

Published on: May 26, 2014

Soot carbon and excess fine potassium: long-range transport of combustion-derived aerosols

M O Andreae

    Science (New York, N.Y.)
    |June 10, 1983
    PubMed

    More Related Videos

    Split Point Analysis and Uncertainty Quantification of Thermal-Optical Organic/Elemental Carbon Measurements10:22

    Split Point Analysis and Uncertainty Quantification of Thermal-Optical Organic/Elemental Carbon Measurements

    Published on: September 7, 2019

    Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer07:24

    Combustion Chemistry of Fuels: Quantitative Speciation Data Obtained from an Atmospheric High-temperature Flow Reactor with Coupled Molecular-beam Mass Spectrometer

    Published on: February 19, 2018

    Related Concept Videos

    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
    The Sulfur Cycle01:22

    The Sulfur Cycle

    Sulfur, an important element in the chemical makeup of proteins, is recycled through the atmosphere and aquatic and terrestrial environments. Found in the atmosphere as sulfur dioxide (SO2), sulfur is released by decaying organisms, weathered rocks, geothermal vents, volcanos, and burning fossil fuels. It is deposited into the ecosystem, cycled through the biotic community, and either released back into the atmosphere as gas or deposited in marine sediment for long-term storage and eventual...
    The Carbon Cycle01:14

    The Carbon Cycle

    Carbon is the basis of all organic matter on Earth, and is recycled through the ecosystem in two primary processes: one in which carbon is exchanged among living organisms, and one in which carbon is cycled over long periods of time through fossilized organic remains, weathering of rocks, and volcanic activity. Human activities, including increased agricultural practices and the burning of fossil fuels, has greatly affected the balance of the natural carbon cycle.
    Alkali Metals03:06

    Alkali Metals

    Group 1 elements are soft and shiny metallic solids. They are malleable, ductile, and good conductors of heat and electricity. The melting points of the alkali metals are unusually low for metals and decrease going down the group, while the density increases going down the group with the exception of potassium (Table 1).
    Table 1: Properties of the alkali metals
    Washing, Drying, and Ignition of Precipitates00:52

    Washing, Drying, and Ignition of Precipitates

    After filtration, the precipitate is washed to remove coprecipitated impurities and any remaining mother liquor. Colloidal precipitates, such as silver chloride, are washed with an electrolyte (such as dilute nitric acid) to prevent the peptization of the precipitate. In the case of slightly soluble precipitates, the wash solution contains a common ion to reduce solubility. Lead sulfate, which is slightly soluble in water, is washed with dilute sulfuric acid. Similarly, wash solutions may be...
    Atomic Emission Spectroscopy: Interference01:30

    Atomic Emission Spectroscopy: Interference

    In atomic emission spectroscopy (AES), high-temperature atomizers excite a broad range of elements and molecules that generate complex emissions from sources such as oxides, hydroxides, and flame combustion products in the flame or plasma. Several strategies can be employed to minimize spectral interferences caused by overlapping emission lines or bands. These include increasing instrument resolution, choosing alternative emission lines, optimally placing the detector in low-background regions,...