Related Experiment Video
Updated: Jul 8, 2026
Quasistatic Mechanical Testing for Computer-Aided Design and Manufacturing Occlusal Veneers Cemented to Milled Dentin Analog Material
Published on: December 20, 2024
Morphological study of fiber-reinforced post-bonding system-root dentin interface by evaluation of two bonding
Emmanuelle Esclassan Noirrit1, Geneviève Grégoire, Maxime Cournot
1Biomaterials Laboratory, Faculty of Odontology, University of Toulouse III, Toulouse, France. noirrit@cict.fr <noirrit@cict.fr>
Unlabelled:
Morphological study of fiber post/bonding system/root dentin interface by evaluation of two bonding systems.
Objectives:
The aim of the study was to analyze the interfaces, and thus the seal, between root dentin and bonded fiber-reinforced posts. The interfaces were obtained by applying two enamel-dentin adhesive systems, a one-bottle system used after application of phosphoric acid and a self-etch system, both used with an adhesive cement. The interface was evaluated by SEM observation of the continuity of the hybrid layer and the morphology of the resin tags, in terms of length, density and presence of side branches, at the interface between the fiber-reinforced post, the bonding system and the root dentin.
Methods:
Twenty-six anterior single-rooted teeth extracted for periodontal reasons were treated endodontically and then randomly separated into two groups of 13 teeth each: group 1: Excite DSC (Ivoclar Vivadent, Liechtenstein); group 2: AdheSE DC (Ivoclar Vivadent, Schaan, Liechtenstein). After preparation of the root canal and application of the adhesive, each specimen received a Postec translucent FRC post (Ivoclar Vivadent, Schaan, Liechtenstein) that was cemented in with Variolink II dual-curing luting composite (Ivoclar Vivadent, Schaan, Liechtenstein). The specimens were then prepared for SEM observation of the continuity of the hybrid layer and scoring of the morphology of the resin tags in each third of the root (at 1, 4.5 and 8mm from the coronal surface).
Results:
There was no significant difference (at p<0.05) between the two groups in terms of continuity of the hybrid layer or morphology of the resin tags. The hybrid layer was present, unbroken and uniform in both the group where adhesive was used with a phosphoric acid total etch and the self-etch system group. Whatever the bonding system, the resin tags had side branches, and greater length and density in the cervical third than in the middle or apical thirds. Bubbles were found in the cement layer in most of the specimens.
Conclusions:
The one-bottle and self-etch bonding systems gave similar results in terms of interface morphology when a translucent fiber-reinforced post was cemented into the endodontically prepared roots.
