Measurement of elastic modulus s(11)(D) of thin film ZnO by resonance method
Abstract:
The elastic modulus of thin film ZnO has been measured by attaching a Si-ZnO strip to a ceramic bimorph, deflecting the latter with an electric signal, and measuring the resonance frequencies of the Si-ZnO strip. The resonance frequencies of the Si-ZnO strip depend on the properties of both Si and ZnO. The properties of Si are known, and, thus, the elastic modulus of thin film ZnO can be calculated from the resonance frequency of the beam. The results we obtained are presented in this report.
Related Concept Videos
01:16Dynamic Modulus of Elasticity of Concrete
The dynamic modulus of elasticity assesses how a concrete structure deforms under impact or dynamic loads. It is typically higher than the static modulus of elasticity, measured under slow, steady loading conditions.
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
01:15Strain and Elastic Modulus
The quantity that describes the deformation of a body under stress is known as strain. Strain is given as a fractional change in either length, volume, or geometry under tensile, volume (also known as bulk), or shear stress, respectively, and is a dimensionless quantity. The strain experienced by a body under tensile or compressive stress is called tensile or compressive strain, respectively. In contrast, the strain experienced under bulk stress and shear stress is known as volume and shear...
01:15Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity
Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
01:20Elastic Strain Energy for Shearing Stresses
As discussed in previous lessons, strain energy in a material is the energy stored when it is elastically deformed, a concept crucial in materials science and mechanical engineering. This energy results from the internal work done against the cohesive forces within the material. When a material undergoes shearing stress and corresponding shearing strain, the strain energy density, which is the energy stored per unit volume, is calculated. Within the elastic limit, where the stress is...