Related Experiment Video

Updated: Jul 7, 2026

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions
08:18

Design and Use of a Full Flow Sampling System (FFS) for the Quantification of Methane Emissions

Published on: June 12, 2016

[Characteristics of fugitive dust pollution in different construction phases]

Yu-hu Huang1, Gang Tian, Jian-ping Qin

  • 1Beijing Municipal Research Institute of Environmental Protection, Beijing 100037, China.

Huan Jing Ke Xue= Huanjing Kexue
|February 23, 2008
PubMed

More Related Videos

Experimental Methods of Dust Charging and Mobilization on Surfaces with Exposure to Ultraviolet Radiation or Plasmas07:54

Experimental Methods of Dust Charging and Mobilization on Surfaces with Exposure to Ultraviolet Radiation or Plasmas

Published on: April 3, 2018

A System to Create Stable Nanoparticle Aerosols from Nanopowders12:59

A System to Create Stable Nanoparticle Aerosols from Nanopowders

Published on: July 26, 2016

Related Concept Videos

Efflorescence in Masonry01:25

Efflorescence in Masonry

Efflorescence in masonry walls appears as a fluffy crystalline powder, often white, resulting from water-soluble salts within the masonry or mortar. When water penetrates the masonry, it dissolves these salts and brings them to the surface, where they are deposited upon evaporation of water.
While initial efflorescence is common post-construction and can be cleaned with water and a brush, in certain instances, efflorescence can reappear and gradually diminish over time as salts are leached out...
Deleterious Substances in Aggregate01:25

Deleterious Substances in Aggregate

Deleterious substances in aggregates can be detrimental to the quality and durability of concrete. These substances include organic impurities like loam, which interfere with cement hydration and are usually present in the sand. These prevent a good bond between aggregate and cement paste. Organic impurities can be detected using the colorimetric test, where the darkness of a solution after agitation indicates the level of organic content.
Another type of impurity is clay and fine material that...
Design Example: Managing Concrete Workability01:14

Design Example: Managing Concrete Workability

This example deals with managing the workability of concrete for a raft foundation project under hot weather conditions. Workability is crucial for ensuring the concrete is easy to place, compact, and finish. In this scenario, a slump test — a common method to measure the workability of fresh concrete — initially indicated low workability. This was attributed to the rapid water loss from the concrete mix, exacerbated by the high temperatures causing the course aggregates to heat up.
To address...
Chronic Obstructive Pulmonary Disease I: Introduction01:23

Chronic Obstructive Pulmonary Disease I: Introduction

Chronic obstructive pulmonary disease is a common, preventable, and treatable respiratory disorder characterized by persistent symptoms and progressive airflow limitation. This limitation results from a combination of small-airway disease (obstructive bronchiolitis) and parenchymal destruction (emphysema), both driven by chronic inflammation from exposure to harmful particles or gases.The disease includes two main pathological entities: emphysema, marked by destruction of alveolar walls and...
Segregation in Fresh Concrete01:16

Segregation in Fresh Concrete

Segregation in fresh concrete is a phenomenon where the components of the concrete mix separate, leading to uneven distribution and compromised structural integrity. This separation typically occurs when concrete is subjected to excessive horizontal movement within forms, or when it is dropped from considerable heights or forced through narrow, winding paths. As a result, heavier coarse aggregate particles settle at the bottom, while lighter, finer materials such as cement and water rise to the...
Air-entraining Agents01:27

Air-entraining Agents

Air-entraining agents improve the durability and workability of concrete in climates with frequent freezing and thawing. These agents prevent cracks by introducing small air bubbles into the mix, creating spaces accommodating water expansion when temperatures drop. The air-entraining agents lower the surface tension of water, forming stable, small air bubbles. This method is more effective than having accidental large voids, as the intentional, smaller, and evenly distributed air voids improve...