Related Experiment Video

Updated: Jul 6, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

Ammonia Detection by use of Near-Infrared Diode-Laser-Based Overtone Spectroscopy

R Claps, F V Englich, D P Leleux

    Applied Optics
    |March 25, 2008
    PubMed

    More Related Videos

    Fast and Accurate Exhaled Breath Ammonia Measurement06:27

    Fast and Accurate Exhaled Breath Ammonia Measurement

    Published on: June 11, 2014

    Characterizing Far-infrared Laser Emissions and the Measurement of Their Frequencies09:38

    Characterizing Far-infrared Laser Emissions and the Measurement of Their Frequencies

    Published on: December 18, 2015

    Related Concept Videos

    NMR Spectroscopy Of Amines01:19

    NMR Spectroscopy Of Amines

    In proton NMR spectroscopy, primary amines and secondary amines showcase their N–H protons as a broad signal in the chemical shift range between δ 0.5 and 5 ppm. The exact position in this range depends on several factors, including sample concentration, hydrogen bonding, and the type of solvent used. Since amine protons undergo fast proton exchange in solution, the protons are labile and therefore do not participate in any splitting with adjacent protons. Thus, the observed peak is broad and...
    IR and UV–Vis Spectroscopy of Aldehydes and Ketones01:29

    IR and UV–Vis Spectroscopy of Aldehydes and Ketones

    Infrared spectroscopy, also known as vibrational spectroscopy, is mainly used to determine the types of bonds and functional groups in molecules. In aldehydes and ketones, the carbonyl (C=O) bond shows an absorption around 1710 cm-1. The C=O bond vibration of an aldehyde occurs at lower frequencies than that of a ketone. In addition to the C=O absorption in an aldehyde, the aldehydic C–H bond also gives two peaks in the 2700–2800 cm-1 range. This absorption, coupled with the C=O stretching, is...
    Raman Spectroscopy Instrumentation: Overview01:26

    Raman Spectroscopy Instrumentation: Overview

    A conventional Raman spectrophotometer includes a laser source, a sample holding system, a wavelength selector, and a detector.
    The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...
    IR Frequency Region: X–H Stretching01:24

    IR Frequency Region: X–H Stretching

    In IR spectroscopy, signals produced by the X−H bonds (such as C−H, O−H, or N−H) can be observed in the frequency range of  2700–4000 cm–1. The C−H stretching vibration forms sharp bands in the region 2850–3000 cm–1. The presence of the O−H stretching vibration leads to the forming of an absorption band in the frequency range 3650–3200 cm−1. At the same time, N−H stretching can be confirmed by absorption bands in the 3500–3100 cm−1 range. Even though both O−H and N−H bonds vibrate at a similar...
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single stretching vibration...
    Spectroscopy of Carboxylic Acid Derivatives01:26

    Spectroscopy of Carboxylic Acid Derivatives

    Infrared spectroscopy is primarily used to determine the types of bonds and functional groups. In carboxylic acid derivatives, a typical carbonyl bond absorption is observed around 1650–1850 cm−1. For esters, the absorption is recorded at around 1740 cm−1, while acid halides show the absorption at about 1800 cm−1. Another acid derivative, the acid anhydrides, exhibit two carbonyl absorption around 1760 cm−1 and 1820 cm−1, arising from the symmetrical and unsymmetrical carbonyl vibration.
    In the...