Related Experiment Video
Updated: Jul 5, 2026

Ligand-Mediated Nucleation and Growth of Palladium Metal Nanoparticles
Published on: June 25, 2018
Supersensitivity of transition-metal nanoparticle formation to initial precursor concentration and reaction
Lisa Starkey Ott1, Richard G Finke
1Department of Chemistry, Colorado State University, Fort Collins, CO 80523, USA.
Abstract:
A supersensitivity of the formation and stabilization of transition-metal nanoclusters to the initial nanocluster concentration and temperature synthesis conditions is reported, then probed, herein for the specific case of prototype Ir(O)n nanoclusters prepared from the organometallic precursor [Bu4N]5Na3[(1,5-COD)Ir x P2W15Nb3O62] by reduction with H2 in propylene carbonate solvent. Fully isolable, redissolvable, near-monodisperse (i.e., < or = +/- 15% size distribution) and thus excellent Ir(O)n nanoclusters are formed using low temperature (22 degrees C) and moderate precursor concentration (1.2 mM) in propylene carbonate solvent. However, inferior, polydisperse (+/- 40% size distribution), non-redispersable nanoclusters are formed at the seemingly only moderately different conditions of 38 degrees C higher temperature (i.e., 60 degrees C) and 5-fold lower precursor concentration (0.24 mM). Investigation of this supersensitivity to the nanocluster synthesis conditions reveals that it derives from the dissociation of (1,5-COD)Ir(solvent)2+ from the P2W15Nb3O62(9-) polyanionic ligand/ stabilizer, subsequently resulting in a too fast, kinetically uncontrolled reduction of the quickly reduced (1,5-COD)Ir(solvent)2+ as the cause of the inferior synthesis of polydisperse, non-isolable, non-redissolvable nanoclusters. The results are significant in that they illustrate that understanding the mechanism of nanocluster formation, and then performing the nanocluster synthesis under kinetically carefully controlled, understood conditions, is necessary for the formation of superior nanoclusters in this, and by implication probably many other, cases.
Related Concept Videos
Precipitate Formation and Particle Size Control
The obtained precipitate should be either a pure substance of known composition or easily converted to one by a simple process, such as ignition or drying. In addition, the precipitate should be insoluble and easily filterable. In general, filterability...
Temperature Dependence on Reaction Rate
Atoms, molecules, or ions must collide before they can react with each other. Atoms must be close together to form chemical bonds. This premise is the basis for a theory that explains many observations regarding chemical kinetics, including factors affecting reaction rates.
The collision theory is based on the postulates that (i) the reaction rate is proportional to the rate of reactant collisions, (ii) the reacting species collide in an orientation allowing contact between...
Colloidal precipitates
Formation of Complex Ions

