Related Experiment Video
Updated: Jan 24, 2026

Preparation and Characterization of Nanoliposomes for the Entrapment of Bioactive Hydrophilic Globular Proteins
Published on: August 31, 2019
Hydrophilic alcohol ethoxylates as efficiency boosters for microemulsions
Christian Frank1, Henrich Frielinghaus, Jürgen Allgaier
1Institut für Festkörperforschung, Forschungszentrum Jülich GmbH, 52425 Jülich, Germany.
Abstract:
Highly amphiphilic polyalkane-PEO diblock copolymers drastically increase the solubilization capacity of surfactants in microemulsions if they are used in small quantities as additive to the surfactant. This effect goes along with an additional reduction of the already very low interfacial tension between water and oil. Lamellar phases, which usually develop when the surfactant becomes more efficient, are suppressed to a large extent. In this work we use another type of additive, namely hydrophilic alcohol ethoxylates. These amphiphiles are identical with the previously used block copolymers with respect to the hydrophilic moiety. However, they contain only small hydrocarbon groups ranging from C8 to C18. A typical example from the hydrophilic alcohol ethoxylates is C12E100. Both additive types increase surfactant efficiency equally with respect to mass fraction in the mixture. Because the alcohol ethoxylate additives decorate the surfactant film only on the aqueous side, they influence the curvature of the surfactant membrane or, in other words, the temperature behavior of the microemulsion. Together with nonionic surfactants, however, the shift of the one-phase region to higher temperatures is only a few degrees Celsius. Just as with the polyalkane-PEO block copolymers, the hydrophilic alcohol ethoxylates suppress lamellar phases. This behavior is especially pronounced if the hydrophobic groups are small or the PEO chains are long. We found that hydrophobic units as short as C 8 are sufficient to largely anchor the PEO chains at the interface. If C12 or C18 hydrocarbon unit are used instead, the PEO chains are fully interfacially active, even if the hydrophilic chain contains up to about 500 EO units. We applied the new additives in bicontinuous and in droplet microemulsions and used nonionic, as well as ionic, surfactants, namely C10E4 and AOT. In contrast to polyalkane-PEO blockcopolymers the new additives are easy to synthesize and are commercially available. Therefore, they might be interesting in applications.
More Related Videos
Related Concept Videos
Oxidation of Alcohols
The process of oxidation in a chemical reaction is observed in any of the three forms:
Ethers from Alcohols: Alcohol Dehydration and Williamson Ether Synthesis
Ethers can be prepared from organic compounds by various methods. Some of them are discussed below,
Preparation of Ethers by Alcohol Dehydration
In this method, in the presence of protic acids, alcohol dehydrates to produce alkenes and ethers under different conditions. For example, in the presence of sulphuric acid, dehydration of ethanol at 413 K yields ethoxyethane, whereas it yields ethene at 443 K.
Protection of Alcohols
Protection
It defines a protecting group as the masking agent to make the more reactive species inert to a given set of conditions. This concept is depicted via the illustration of liquid flow through different outlets in an assembly of pipes. The analogy helps to understand the role...
Preparation of Alcohols via Substitution Reactions
Alcohols can be synthesized from alkyl halides via nucleophilic substitution reactions. The highly polar carbon-halogen bond in the substrate makes halide a good leaving group. The hydroxide ion or water can act as a nucleophile to take the place of halide and form an alcohol. The substitution reactions occur via two different reaction pathways, SN1 or SN2, depending on the nature of carbon attached to the halide.
Primary alcohols are synthesized from primary alkyl halides, and the...
Esters to Alcohols: Hydride Reductions
Lithium aluminum hydride is a source of hydride ions and functions as a nucleophile. The mechanism proceeds in three steps. Firstly, the nucleophilic hydride ion attacks the carbonyl carbon of the ester to form a tetrahedral intermediate. Subsequently, the carbonyl group re-forms,...
Esters to Alcohols: Grignard Reaction
The reaction requires two equivalents of the Grignard reagent and introduces two identical alkyl groups, derived from the Grignard reagent, bonded to the hydroxyl-bearing carbon of the alcohol.
The reaction follows the typical nucleophilic acyl substitution mechanism. The Grignard...

