Recycle use of immobilized glucoamylase by tangential flow filtration unit

Various properties of glucoamylase immobilized onto corn stover supporting material and separation of immobilized enzyme by tangential flow filtration unit were studied. Optimum pH and temperature of immobilized enzyme were 3.5 and 60 degrees C, respectively. Enzyme stability was studied in a packed-bed column. The starch conversion rate was attained at 81% for 15 days; after that, the hydrolysis rate gradually decreased. Size of supporting material proved to be an important factor, with higher activity and good loading yield resulting from smaller supporting material. Glucoamylase immobilized onto supporting material less than 44 microm was used for hydrolysis of 10% soluble starch at pH 3.5 and 40 degrees C for 3 h. Then immobilized glucoamylase was separated from the product by means of a tangential flow filtration unit using a 0.2-microm pore size Nylon 66 membrane filter. This operation was continued until 180 ml filtrate was obtained from a 260-mL starting volume. Then, the next batch was started by adding 180 mL starch substrate into the reactor. The batchwise experiments were repeated 20 times. The average filtration rate of each batch was determined and found to sharply decline during the first four batches. Thereafter, it gradually decreased from batch to batch. The cause of decreasing filtration rate appeared to be due to retrogradation of starch. The percentage of starch hydrolysis within 20 batches was in the range 89-96%. The filtration rate becomes higher if the hydrolyzation time is extended to 14 h. Resistance to filtration was also investigated. Almost all of the total resistance is related to insoluble materials, with the significant part of this from the resistance due to insoluble materials deposited on a surface of membrane and boundary layer resistance. Using a microscopic method, no microorganisms were found in the filtrate.