Acetone-butanol-ethanol (ABE) fermentation in an immobilized cell trickle bed reactor

C H Park1, M R Okos, P C Wankat

  • 1Departments of Chemical and Agricultural Engineering, Purdue University, West Lafayette, Indiana 47907, USA.

Related Concept Videos

Production of Alcohol01:27

Production of Alcohol

Continuous fermentation is a key strategy in industrial ethanol production, particularly when efficiency, scalability, and high yields are essential. This approach allows for uninterrupted operation and optimized resource utilization. The primary feedstock, corn starch, undergoes enzymatic hydrolysis facilitated by α-amylase and glucoamylase. These enzymes break down the starch into fermentable sugars such as glucose, which are readily assimilated by fermentative microorganisms.Fermentation...
Bioreactor Controls-II01:18

Bioreactor Controls-II

In aerobic fermentations, oxygen is vital for microbial growth and metabolite production. Since air comprises only about 20% oxygen and the gas is poorly soluble in water—just 9 ppm at 20°C—supplying sufficient oxygen becomes a critical challenge, especially in high-demand processes like yeast growth or citric acid production. Even a fully saturated broth may offer only a few seconds of oxygen availability.To address this, sterile or scrubbed air is introduced into the fermentor via a sparger...
Bioreactor Design and Operational System01:29

Bioreactor Design and Operational System

Bioreactors are engineered vessels designed to cultivate microorganisms under controlled conditions for industrial bioprocessing. They maintain sterility and allow precise regulation of pH, temperature, oxygen, and nutrient levels to optimize microbial growth and metabolite production. Bioreactors range from small laboratory units of 1 liter to industrial systems holding up to 500,000 liters, though only about 75% of their volume is actively used for fermentation. The remaining headspace...
Bioreactor Controls-III01:22

Bioreactor Controls-III

Strain improvement is a foundational strategy in industrial microbiology aimed at maximizing microbial productivity, particularly because natural isolates typically yield commercially valuable products in very low concentrations. Although optimizing the culture medium and environmental conditions can improve yields, these adjustments are inherently limited by the organism’s genetic potential. As a result, the focus shifts toward genetic modifications to enhance biosynthetic capacity. The...
Fates of Pyruvate01:20

Fates of Pyruvate

Pyruvate is the end product of glycolysis, where glucose is oxidized to pyruvate, simultaneously reducing NAD+ to NADH. Two molecules of ATP are also produced by substrate-level phosphorylation.
In aerobic organisms, pyruvate is metabolized via the citric acid cycle to produce reduced coenzymes NADH and FADH2. These coenzymes are then oxidized in the electron transport chain to produce ATP and, in the process, regenerate the NAD+ and FAD. As seen in some cell types and organisms, fermentation...
Production of Antibiotics01:27

Production of Antibiotics

Penicillin, one of the earliest and most widely used antibiotics, is produced industrially by the filamentous fungus Penicillium chrysogenum. Large stirred-tank bioreactors ranging from tens to hundreds of thousands of liters maintain tightly controlled temperature, pH, and dissolved oxygen conditions to support fungal metabolism and maximize antibiotic yield. Penicillin is a secondary metabolite, synthesized primarily during the stationary growth phase, which requires a carefully managed...