[Problems concerning the integration of "derived-no-effect-levels" (DNELS) into occupational safety and health

Jan Gromiec1

  • 1Zakład Zagrozeń Chemicznych, Instytut Medycyny Pracy im. prof. J. Nofera, Lódź. jpgrom@imp.lodz.pl

Medycyna Pracy
|July 31, 2008
PubMed

Related Concept Videos

Difference from Background: Limit of Detection01:05

Difference from Background: Limit of Detection

The limit of detection (LOD) is the smallest amount of analyte that can be distinguished from the background noise. The LOD value corresponds to the concentration at which the analyte signal is three times larger than the standard deviation of the blank signal. Below this value, the analyte signal cannot be differentiated from the background noise. It is calculated by dividing the calibration slope by 3 times the standard deviation of the blank signals.
The LOD indicates the presence or absence...
Drug Regulation01:25

Drug Regulation

Drug regulation encompasses the management of drug usage by evaluating its safety and efficacy through assessments conducted by regulatory authorities. Regrettably, the history of drug regulation is marred by several catastrophic events. One such incident is the Elixir Sulfanilamide tragedy, in which the toxic compound diethyl glycol was included in a sweet-tasting medication, leading to numerous fatalities. This event prompted the enactment of the Food, Drug, and Cosmetic Act in 1938. Under...
Dose Response Curve: Conventional Versus Nonmonotonic01:21

Dose Response Curve: Conventional Versus Nonmonotonic

The correlation between a drug's dosage and its impact on a biological system is a cornerstone of pharmacology and toxicology. Conventional dose–response curves, which include graded and quantal relationships, are key to this understanding. Graded dose–response curves depict the spectrum of a biological reaction to different doses within an individual, indicating that as the drug dosage increases, so does the intensity of the response. On the other hand, quantal dose–response relationships...
Toxicity Testing in Animals01:23

Toxicity Testing in Animals

Toxicity tests in animals are grounded on two main assumptions: first, the effects observed in laboratory animals can be extrapolated to humans, especially when adjusted for body surface area; second, high-dose exposure in animals is essential to identify potential human hazards from lower doses. This is based on the quantal dose-response concept, which faces the challenge of extrapolating results from relatively few test animals to much larger human populations. For example, a 0.01% incidence...
Criteria for Causality: Bradford Hill Criteria - II01:28

Criteria for Causality: Bradford Hill Criteria - II

The Bradford Hill criteria serve as guidelines for establishing causative links in epidemiological research. Beyond Strength, Consistency, Specificity, and Temporality, key criteria also include Biological Gradient, Plausibility, Coherence, Experiment, and Analogy. These principles assist scientists in assessing the likelihood of causation in complex biological contexts. Below is a summary of these concepts:
PPE Use in Healthcare Settings II: Doffing01:10

PPE Use in Healthcare Settings II: Doffing

The sequence of removing or doffing PPE starts with the gloves, as they are the most contaminated. Next is removal of the face shield or goggles, as they would interfere with removing other PPE. Then remove the gown, followed by the mask or respirator. Perform hand hygiene between steps if hands become contaminated and immediately after removing all PPE. Generally, the outside front and sleeves of the isolation gown, the goggles or the mask, the respirator, and the face shield are contaminated.