Related Experiment Video
Updated: Jun 30, 2026

Waste Water Derived Electroactive Microbial Biofilms: Growth, Maintenance, and Basic Characterization
Published on: December 29, 2013
The effect of different substrates and humic acid on power generation in microbial fuel cell operation
Anders Thygesen1, Finn Willy Poulsen, Booki Min
1Biosystems Department, National Laboratory for Sustainable Energy, Technical University of Denmark, Roskilde, Denmark. anders.thygesen@risoe.dk
Abstract:
Electricity production from acetate, glucose and xylose with humic acid as mediator was investigated in two chambers microbial fuel cells (MFCs). Acetate produced the highest voltage (570 mV with 1000 Omega) and maximum power density (P(maxd)=123 mW/m(2)) due to a simpler metabolism than with glucose and xylose. Glucose and xylose resulted in P(maxd) of 28 mW/m(2) and 32 mW/m(2) at lower voltage of 380 mV and 414 mV, respectively. P(maxd) increased by 84% and 30%, for glucose and xylose respectively, when humic acid (2g/l) was present in the medium. No significant effect was found with acetate since the internal resistance possessed a limiting effect. The increase of P(maxd) due to humic acid presence was attributed to its ability to act as mediator. Even though pH decreased to 5 with glucose and xylose, due to production of acetate and propionate, the voltage remained on the same level of 250-350 mV.
Related Concept Videos
Microbial Fuel Cells
Microbial Wastewater Treatment
Environmental Applications of Microorganisms
Microbes and Methanogenesis
Microbial Bioremediation of Hydrocarbons
Microbial Mats

