The evidence provided by a single trial is less reliable than its statistical analysis suggests

George F Borm1, Oscar Lemmers, Jaap Fransen

  • 1Department of Epidemiology, Biostatistics and HTA, Radboud University Nijmegen Medical Centre, Nijmegen, The Netherlands. g.borm@ebh.umcn.nl

Abstract

Related Concept Videos

Testing a Claim about Population Proportion01:24

Testing a Claim about Population Proportion

A complete procedure for testing a claim about a population proportion is provided here.
There are two methods of testing a claim about a population proportion: (1) Using the sample proportion from the data where a binomial distribution is approximated to the normal distribution and (2) Using the binomial probabilities calculated from the data.
The first method uses normal distribution as an approximation to the binomial distribution. The requirements are as follows: sample size is large...
Statistical Significance01:37

Statistical Significance

Once data is collected from both the experimental and the control groups, a statistical analysis is conducted to find out if there are meaningful differences between the two groups. A statistical analysis determines how likely any difference found is due to chance (and thus not meaningful). In psychology, group differences are considered meaningful, or significant, if the odds that these differences occurred by chance alone are 5 percent or less. Stated another way, if we repeated this...
Bonferroni Test01:10

Bonferroni Test

The Bonferroni test is a statistical test named after Carlo Emilio Bonferroni, an Italian mathematician best known for Bonferroni inequalities. This statistical test is a type of multiple comparison test to determine which means are different than the rest. Bonferroni test can minimize the Type 1 error by reducing the significance level alpha, which otherwise increases with sample pairs.
The means of different samples are first paired in all possible combinations.
The null hypothesis of the...
Cause and Effect01:53

Cause and Effect

While variables are sometimes correlated because one does cause the other, it could also be that some other factor, a confounding variable, is actually causing the systematic movement in our variables of interest. For instance, as sales in ice cream increase, so does the overall rate of crime. Is it possible that indulging in your favorite flavor of ice cream could send you on a crime spree? Or, after committing crime do you think you might decide to treat yourself to a cone?
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
Testing a Claim about Standard Deviation01:19

Testing a Claim about Standard Deviation

A complete procedure to test a claim about population standard deviation or population variance is explained here.
The hypothesis testing for the claim of population standard deviation (or variance) requires the data and samples to be random and unbiased. The population distribution also must be normal. There is no specific requirement on the sample size as the estimation is based on the chi-square distribution.
As a first step, the hypothesis (null and alternative) concerning the claim about...