Unity is strength: staff college and the British officer corps

Anthony King1

  • 1School of Humanities and Social Science, University of Exeter. a.c.king@exeter.ac.uk

Related Concept Videos

Conservative Forces01:03

Conservative Forces

Conservative forces are an essential concept in the field of mechanical engineering. Understanding the properties and characteristics of these forces is crucial to the design and analysis of mechanical systems.
Conservative forces are forces that are dependent only on the initial and final positions of an object and that are independent of the path that the object takes between these positions. These forces conserve energy, which means that the work done by the force is independent of the path...
Conservative Forces01:14

Conservative Forces

According to the law of conservation of energy, any transition between kinetic and potential energy conserves the total energy of the system. Hence, the work done by a conservative force is completely reversible. It is path independent, which means that we can start and stop at any two points in the transition, and the total energy of the system (kinetic plus potential energy at these points) will remain conserved. This is characteristic of a conservative force. Some important examples of...
Three Force Member01:27

Three Force Member

A rigid body subjected to three forces acting at three points is known as a three-force member. These forces must have concurrent lines of action, except for parallel forces, where the lines of action are parallel.
For example, consider a dumpster connected to a pin support at point A and a pin attached to a hydraulic cylinder at point B.
Two Force Member01:30

Two Force Member

The equilibrium of a two-force body is a particular case that is often encountered in practical applications. A two-force body is a rigid body that is subjected to only two external forces. For such a body to be in equilibrium, the two forces must have the same magnitude, the same line of action, and the opposite direction.
Strength of Cement01:20

Strength of Cement

Strength tests for cement are not performed directly on neat cement paste due to difficulty in obtaining consistent, reliable specimens. Instead, cement is typically tested in the form of cement-sand mortar.
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in ASTM C...
Introduction to force01:25

Introduction to force

Consider water flowing from a nozzle to a turbine vane. As the water hits the turbine vane, it exerts a force that causes it to move along the flow of direction. Force is an impact that changes an object's motion, shape, or orientation. Forces can be caused by physical contact, such as a push or pull, or through non-contact interactions, such as magnetic or gravitational forces. Force is a vector quantity with both magnitude and direction, and is measured in newtons (N) in the SI unit system.