QSPR modeling of enthalpies of formation for organometallic compounds by SMART-based optimal descriptors

Andrey A Toropov1, Alla P Toropova, Emilio Benfenati

  • 1Institute of Geology and Geophysics, Laboratory of Physicochemical Methods of Analysis, Khodzhibaev Street 49, 100041 Tashkent, Uzbekistan. aatoropov@yahoo.com

Related Concept Videos

Standard Enthalpy of Formation02:37

Standard Enthalpy of Formation

Enthalpy changes are typically tabulated for reactions in which both the reactants and products are at the same conditions. A standard state is a commonly accepted set of conditions used as a reference point for the determination of properties under other different conditions. For chemists, the IUPAC standard state refers to materials under a pressure of 1 bar and solutions at 1 M and does not specify a temperature. Many thermochemical tables list values with a standard state of 1 atm. Because...
Properties of Organometallic Compounds01:23

Properties of Organometallic Compounds

Organometallic compounds are compounds that contain a carbon–metal bond. Carbon belongs to an organyl group like alkyl, aryl, allyl, or benzyl groups. The metal can be from Group I or Group II of the periodic table, a transition metal, or a semimetal.
Regioselective Formation of Enolates01:33

Regioselective Formation of Enolates

As depicted in the figure below, the unsymmetrical ketones can form two possible enolates: less substituted or more substituted enolates. Usually, the thermodynamic enolates are formed from the more substituted α-carbon atom, while the kinetic enolates are formed faster by deprotonation from the less substituted position. The thermodynamic enolates have lower energy, so they are more stable. But the energy required to form kinetic enolates is less.
VSEPR Theory and the Basic Shapes02:52

VSEPR Theory and the Basic Shapes

Overview of VSEPR Theory
Experimental Determination of Chemical Formula02:37

Experimental Determination of Chemical Formula

The elemental makeup of a compound defines its chemical identity, and chemical formulas are the most concise way of representing this elemental makeup. When a compound’s formula is unknown, measuring the mass of its constituent elements is often the first step in determining the formula experimentally.
Enthalpies of Reaction03:33

Enthalpies of Reaction

Hess’s law can be used to determine the enthalpy change of any reaction if the corresponding enthalpies of formation of the reactants and products are available. The main reaction may be divided into stepwise reactions : (i) decompositions of the reactants into their component elements, for which the enthalpy changes are proportional to the negative of the enthalpies of formation of the reactants, −ΔHf°(reactants), followed by (ii) re-combinations of the elements (obtained in step 1) to give...