Related Experiment Video

Updated: Jun 23, 2026

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids
11:03

An Analog Macroscopic Technique for Studying Molecular Hydrodynamic Processes in Dense Gases and Liquids

Published on: December 4, 2017

Scaling analysis of dynamic heterogeneity in a supercooled Lennard-Jones liquid

Richard S L Stein1, Hans C Andersen

  • 1Department of Chemistry, Stanford University, Stanford, California 94305, USA. rstein@ucsd.edu

Physical Review Letters
|May 14, 2009
PubMed

More Related Videos

Orientational Transition in a Liquid Crystal Triggered by the Thermodynamic Growth of Interfacial Wetting Sheets06:26

Orientational Transition in a Liquid Crystal Triggered by the Thermodynamic Growth of Interfacial Wetting Sheets

Published on: May 15, 2017

Analyzing Melts and Fluids from Ab Initio Molecular Dynamics Simulations with the UMD Package06:37

Analyzing Melts and Fluids from Ab Initio Molecular Dynamics Simulations with the UMD Package

Published on: September 17, 2021

Related Concept Videos

Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
Phase Transitions: Vaporization and Condensation02:39

Phase Transitions: Vaporization and Condensation

The physical form of a substance changes on changing its temperature. For example, raising the temperature of a liquid causes the liquid to vaporize (convert into vapor). The process is called vaporization—a surface phenomenon. Vaporization occurs when the thermal motion of the molecules overcome the intermolecular forces, and the molecules (at the surface) escape into the gaseous state. When a liquid vaporizes in a closed container, gas molecules cannot escape. As these gas phase molecules...
Nonideal Two-Component Liquid Solutions01:29

Nonideal Two-Component Liquid Solutions

Nonideal liquid solutions, also known as real solutions, do not strictly follow Raoult's law. Raoult's law is a rule of thumb in physical chemistry. However, not all mixtures adhere to this law due to varying molecular interactions. For example, in an acetone/chloroform solution, the individual vapor pressures of the components are lower than expected, resulting in a total vapor pressure below that predicted by Raoult's law, causing a negative deviation.On the other hand, in an ethanol/water...
Liquid–Solid Solutions01:29

Liquid–Solid Solutions

The process of a solid dissolving in a liquid to form a solution is governed by the solubility limit, which is the maximum amount of the solid substance, or solute, that can be dissolved in a specific volume of the liquid or solvent. As the solute dissolves, it reaches a point where no more solute can be dissolved at a given temperature - this is known as the saturation point. However, if further solute is added and it manages to dissolve, the solution becomes supersaturated. Supersaturated...
Molecular Comparison of Gases, Liquids, and Solids02:26

Molecular Comparison of Gases, Liquids, and Solids

Particles in a solid are tightly packed together (fixed shape) and often arranged in a regular pattern; in a liquid, they are close together with no regular arrangement (no fixed shape); in a gas, they are far apart with no regular arrangement (no fixed shape). Particles in a solid vibrate about fixed positions (cannot flow) and do not generally move in relation to one another; in a liquid, they move past each other (can flow) but remain in essentially constant contact; in a gas, they move...
Two Components: Liquid–Liquid Systems01:27

Two Components: Liquid–Liquid Systems

A pressure-composition phase diagram explicitly describes the behavior of an ideal solution of two volatile liquids under varying pressures and compositions. A pressure-composition diagram has two main curves. The bubble point curve represents the plot of pressure versus liquid mole fraction. It indicates the pressure at which the first bubble of vapor forms from the liquid phase as the system pressure decreases.The dew point curve is the pressure versus vapor mole fraction. It indicates the...