Measurement of plaque-forming macrophages activated by lipopolysaccharide in a micro-channel chip

In the present study, micro-channel arrays were fabricated on the surface of plastic-based disposable chips. The cell adhesion process and the detection of plaque-forming macrophages were observed. Further, we evaluated cell adhesion in a fluid system in vitro.

Features of the micro-channel (1.4 mm wide and 10 mm long) included twenty micro-pillars (with a projection of 200 microm diameter and 250 microm high) coated in a 50 microm thick silicon rubber layer, which were regularly arranged at the bottom of each channel. The efficiency of cell capture was expected to increase by arrangement of micro-pillars in a micro-channel. Mouse macrophage RAW264.7 cells, stimulated for 24 h with lipopolysaccharide (LPS) derived from periodontopathic bacteria, were circulated continuously for 2 h at room temperature by the pump in a chip.

Control cells had not formed plaques on micro-pillars 20 min into the experiment. By contrast, LPS-activated macrophages produced plaques at the side walls of micro-pillars after 20 min. The plaques grew during the flow test, and image shading became clearer with increasing flow time for 120 min. The maximal adhesion rate per unit area appeared at 20% for control cells, whereas the peak was shifted to 30% for LPS-activated macrophages (n = 20). The average adhesion rate was 3.0 +/- 2.0% for control cells and 5.0 +/- 3.9% for LPS-activated macrophages (n = 100).

These findings indicate that LPS-activated macrophages accumulate in micro-channel arrays, and suggest that macrophage plaque formation is a two-step procedure: (1) LPS-activated macrophages adhere physically to the silicon rubber layer on micro-pillars; and (2) consequently, the cells adhere to the activated macrophage layer.