Related Experiment Video

Updated: Jun 22, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

Difference-frequency-generator-based spectrometer at 3 mum for high-sensitivity C2H2 and H2O detection

G Rusciano, G Pesce, F Pignatiello

    Optics Express
    |May 28, 2009
    PubMed

    More Related Videos

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy10:40

    High Resolution Phonon-assisted Quasi-resonance Fluorescence Spectroscopy

    Published on: June 28, 2016

    Ultrafast Time-resolved Near-IR Stimulated Raman Measurements of Functional π-conjugate Systems09:57

    Ultrafast Time-resolved Near-IR Stimulated Raman Measurements of Functional π-conjugate Systems

    Published on: February 10, 2020

    Related Concept Videos

    ¹³C NMR: ¹H–¹³C Decoupling01:04

    ¹³C NMR: ¹H–¹³C Decoupling

    The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
    A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
    IR Frequency Region: Fingerprint Region01:03

    IR Frequency Region: Fingerprint Region

    IR spectra are divided into two main regions: the diagnostic region and the fingerprint region. The diagnostic region of the spectrum lies above 1500 cm−1. The absorptions resulting from single-bond vibrations of the N–H, C–H, and O–H stretch at higher wavenumbers and appear on the left side of the spectrum. The stretching absorptions of the C≡C and C≡N occur between 2100–2300 cm−1. In contrast, those arising from stretching absorptions of the C=O, C=N, and C=C occur between 1600–1850 cm−1.
    The...
    UV–Vis Spectrometers01:14

    UV–Vis Spectrometers

    The absorbance of UV and visible (UV–visible) radiations is measured using a UV–visible spectrophotometer. Deuterium lamps, which emit UV radiation, and tungsten lamps, which produce radiation in the visible region, are used as light sources in UV–visible spectrophotometers. A monochromator or prism is used for diffraction grating, i.e., to split the incoming radiation into different wavelengths. A system of slits is used to focus the desired wavelength on the sample cell. Samples for...
    IR Frequency Region: X–H Stretching01:24

    IR Frequency Region: X–H Stretching

    In IR spectroscopy, signals produced by the X−H bonds (such as C−H, O−H, or N−H) can be observed in the frequency range of  2700–4000 cm–1. The C−H stretching vibration forms sharp bands in the region 2850–3000 cm–1. The presence of the O−H stretching vibration leads to the forming of an absorption band in the frequency range 3650–3200 cm−1. At the same time, N−H stretching can be confirmed by absorption bands in the 3500–3100 cm−1 range. Even though both O−H and N−H bonds vibrate at a similar...
    IR Absorption Frequency: Hybridization01:21

    IR Absorption Frequency: Hybridization

    Hydrocarbons such as alkanes, alkenes, and alkynes show characteristic C–H stretching absorption bands. These IR stretching frequencies depend on the hybridization of the involved carbon atom and can be explained in terms of the s character of each hybridized atomic orbital.
    Among the sp, sp2, and sp3 hybridized orbitals, sp orbitals have the maximum s character (50%). Consequently, the electrons are held more closely to the nucleus, resulting in stronger and shorter C–H bonds that stretch at a...
    Gas Chromatography: Types of Detectors-II01:19

    Gas Chromatography: Types of Detectors-II

    In gas chromatography, different detectors are employed to meet specific analytical needs. These detectors are often categorized based on their detection mechanisms and the types of compounds they are best suited to analyze. Thermal Conductivity Detectors (TCD), Flame Ionization Detectors (FID), and Electron Capture Detectors (ECD) represent common categories, each with unique operating principles and applications. However, beyond these, several other detectors are designed for more specialized...