Related Experiment Video
Updated: Jun 22, 2026
08:48
Writing Bragg Gratings in Multicore Fibers
Published on: April 20, 2016
Flexibly tunable multichannel filter and bandpass filter based on long-period fiber gratings
Optics Express
|May 29, 2009
Abstract:
The voltage-controllable multichannel filter based on multiply cascaded long-period fiber gratings with a divided coil heater will be proposed and experimentally demonstrated. It has several advantages of the large tuning range in both C- and L-band, multichannel operation, multiwavelength electivity, and bandwidth controllability. The tunable bandpass filter based on long-period fiber gratings ith the broad bandwidth over 6.5 nm, large tuning range over 30 nm, and excellent side mode suppression more than 40 dB will be also discussed.
Related Concept Videos
01:27Passive Filters
Passive filters are utilized to shape the frequency spectrum of signals across a diverse array of applications. These filters, using only passive elements like resistors (R), inductors (L), and capacitors (C), are capable of selectively allowing or blocking certain frequency ranges without the need for external power sources.
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff frequency...
Low-Pass Filters
Low-pass filters are designed to transmit signals with frequencies lower than the cutoff frequency, ωc, and attenuate those above it. The cutoff frequency...
01:17Bandpass Sampling
In signal processing, bandpass sampling is an effective technique for sampling signals that have most of their energy concentrated within a narrow frequency band. This type of signal is known as a bandpass signal. The key principle of bandpass sampling involves sampling the signal at a rate that is greater than twice the signal's bandwidth to prevent aliasing.
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...
A bandpass signal has a spectrum with a lower frequency limit, denoted as ω1, and an upper frequency limit, denoted as ω2. The spectrum...
01:25Active Filters
Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is: