Related Experiment Video
Updated: Jun 20, 2026

Rapid Antimicrobial Susceptibility Testing by Stimulated Raman Scattering Imaging of Deuterium Incorporation in a Single Bacterium
Published on: February 14, 2022
Characterization of single heat-activated Bacillus spores using laser tweezers Raman spectroscopy
Pengfei Zhang1, Peter Setlow, Yongqing Li
1Department of Physics, East Carolina University, Greenville, North Carolina 27858-4353, USA.
Abstract:
Heat activation of dormant bacterial spores is a short treatment at a sublethal temperature that potentiates and synchronizes spore germination. In this paper, laser tweezers Raman spectroscopy (LTRS) was used to study the heat activation of single spores of Bacillus cereus and Bacillus subtilis. We measured the Raman spectra of single spores without treatment, during heat activation at 65 degrees C (B. cereus) or 70 degrees C (B. subtilis), and following heat activation and cooling to 25 degrees C. Principle component analysis (PCA) was applied to discriminate among the three groups of spores based on their Raman spectra. The results indicated that: (1) there are large changes in the Raman bands of Ca-DPA and protein for both B. cereus and B. subtilis spores during heat activation, indicative of changes in spore core state and partial protein denaturation at the heat activation temperatures; (2) these spectral changes become smaller once the heated spores are cooled, consistent with heat activation being reversible; (3) minor spectral differences between untreated and heat-activated and cooled spores can be discriminated by PCA based on non-polarized and polarized Raman spectra; and (4) analysis based on polarized Raman spectra reveals that partial denaturation of protein during heat activation is mainly observed in the vertically polarized component.
Related Concept Videos
Raman Spectroscopy: Overview
However, a small fraction of the scattered light exhibits a frequency shift due to the exchange of energy between the incident photons and the...
Raman Spectroscopy Instrumentation: Overview
The monochromatic laser source, typically using visible or near-infrared radiation, generates a highly focused beam of light. This light interacts with the molecules of the sample, scattering some of the light. Liquid and gaseous samples are usually tested in ordinary glass capillaries, while solids can be analyzed as powders packed in capillaries or as potassium...

