Stance width and angle at sea: effects of sea state and body orientation

Thomas A Stoffregen1, Fu-Chen Chen, Yawen Yu

  • 1School of Kinesiology, University of Minnesota, Minneapolis, MN 55455, USA. tas@umn.edu

Abstract

Related Concept Videos

Relative Velocity in Two Dimensions01:11

Relative Velocity in Two Dimensions

Relative velocity is the velocity of an object as observed from a particular reference frame, or the velocity of one reference frame with respect to another reference frame. The concept of relative velocity can be used to describe motion in two dimensions. Consider a particle P and two reference frames S and S′. The position of the origin of S′ as measured in S is , the position of P as measured in S′ is , and the position of P as measured in S is , which can be evaluated by utilizing vector...
Wave Parameters01:10

Wave Parameters

The simplest mechanical waves are associated with simple harmonic motion and repeat themselves for several cycles. These simple harmonic waves can be modeled using a combination of sine and cosine functions. Consider a simplified surface water wave that moves across the water's surface. Unlike complex ocean waves, in surface water waves, water moves vertically, oscillating up and down, whereas the disturbance of the wave moves horizontally through the medium. If a seagull is floating on the...
Influence of Earth's Curvature and Atmospheric Refraction on Leveling01:26

Influence of Earth's Curvature and Atmospheric Refraction on Leveling

During leveling, the Earth's curvature and atmospheric refraction introduce deviations in the line of sight from a true horizontal reference. When the line of sight is leveled, it remains perpendicular to the plumb line only at a single point. Beyond this, it deviates due to the Earth’s curvature, represented by the correction C. For a sight distance D, the deviation can be derived using the relationship:This relationship shows that the deviation increases quadratically with distance. Over a...
Beams with Unsymmetric Loadings01:17

Beams with Unsymmetric Loadings

Analyzing a supported beam under unsymmetrical loadings is essential in structural engineering to understand how beams respond to varied force distributions. This analysis involves calculating the deflection and identifying points where the slope of the beam is zero, which are crucial for ensuring structural stability and functionality.
The first moment-area theorem determines the slope at any point on the beam. This theorem indicates that the change in slope between two points on a beam...
Vectors in 2D: Problem Solving01:29

Vectors in 2D: Problem Solving

A plane traveling due north at 180 km/h in still air was found to be 80 km off-course after 30 minutes, deviating approximately 5 degrees east of north. This deviation means the influence of a crosswind alters the plane’s intended trajectory. The actual ground path formed a diagonal, suggesting that the aircraft’s effective ground speed was reduced to 160 km/h and directed slightly to the east due to the wind.By analyzing the displacement from the intended path, the velocity contributed by the...
Unsymmetric Bending - Angle of Neutral Axis01:15

Unsymmetric Bending - Angle of Neutral Axis

Unsymmetrical bending occurs when a structural member is subjected to bending moments in a plane that does not align with the member's principal axes. This scenario typically arises in beams and other structural components when loads are applied at non-ideal angles, introducing complexities in stress analysis.
When a bending moment is applied at an angle θ concerning the vertical axis of a symmetrical member, it can be resolved into components along the member's principal centroidal axes. The...