Related Experiment Video
Updated: Jun 19, 2026

Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
Published on: May 30, 2014
Frequency shifts in injection-seeded optical parametric oscillators with phase mismatch
Abstract:
We have observed a frequency shift in the output signal pulses relative to the seed frequency in an injection-seeded, singly resonant, critically phase-matched, pulsed optical parametric oscillator in which phase mismatchwas intentionally introduced. The observed shifts can be large compared with the linewidth of the signal pulse, are approximately linear in phase mismatch, and increase with increasing pump fluence. We observe frequencyshifts of as much as +/-400 MHz for our 532-nm-pumped, potassium titanyl phosphate ring optical parametric oscillator. For zero phase mismatch, we observe nearly transform-limited linewidths of less than 130 MHz. Wecompare the experimental data to a simple analytic model that overestimates the shifts because it ignores pumpdepletion. We also compare our measurements with a numerical model that calculates the two-dimensional, transient electric fields and the resultant spectral distributions while explicitly including walk-off, diffraction, and pump depletion. We find good agreement between the experimental data and the results of this model.
Related Concept Videos
Time and frequency -Domain Interpretation of Phase-lead Control
The design of phase-lead control involves the strategic placement of poles and zeros to balance steady-state error and system...
Time and frequency -Domain Interpretation of Phase-lag Control
Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
¹H NMR: Interpreting Distorted and Overlapping Signals
As Δν decreases and the signals move closer, the doublets appear increasingly distorted. The intensities of the inner lines increase at the cost of those of the outer lines as the signals are slanted or...
IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations
Interference: Path Lengths
Two special sources may be considered when they are in phase. This can be easily achieved by feeding the two sources from the same source. An example would be synchronizing the two speakers by feeding them with the same source, such as the sound waves produced by a tuning fork. This setup ensures that the two sources have the same frequency and are...
Gain
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.

