Related Experiment Video

Updated: Jun 19, 2026

Fiber Optic Distributed Sensors for High-resolution Temperature Field Mapping
09:48

Fiber Optic Distributed Sensors for High-resolution Temperature Field Mapping

Published on: November 7, 2016

Nonincremental interferometric fiber-optic measurement method for simultaneous detection of temperature and strain

V Gusmeroli, M Martinelli

    Optics Letters
    |October 27, 2009
    PubMed

    More Related Videos

    Production of a Strain-Measuring Device with an Improved 3D Printer06:17

    Production of a Strain-Measuring Device with an Improved 3D Printer

    Published on: January 30, 2020

    A Random-displacement Measurement by Combining a Magnetic Scale and Two Fiber Bragg Gratings08:23

    A Random-displacement Measurement by Combining a Magnetic Scale and Two Fiber Bragg Gratings

    Published on: September 30, 2019

    Related Concept Videos

    Measurements of Strain01:27

    Measurements of Strain

    Strain quantifies the deformation of a material under force, typically measured as normal strain, which represents the change in length when compared with the original length. Electrical strain gauges are used for enhanced accuracy. These devices consist of a conductive wire mounted on a paper backing that adheres to the material's surface. These gauges operate on the piezoresistive effect, where the wire's electrical resistance changes in response to mechanical deformation. The strain gauge...
    Thermal Strain01:19

    Thermal Strain

    Thermal strain is a concept that arises when we consider how temperature changes affect structures. Unlike the conventional assumption that structures remain constant under load, real-world scenarios often involve temperature fluctuations that can significantly impact these structures. Consider a homogeneous rod with a uniform cross-section resting freely on a flat horizontal surface. If the rod's temperature increases, the rod elongates. This elongation is proportional to the temperature...
    Temperature Dependent Deformation01:12

    Temperature Dependent Deformation

    In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added together...