CO chemisorption on the surfaces of the golden cages

Wei Huang1, Satya Bulusu, Rhitankar Pal

  • 1Department of Physics, Washington State University, 2710 University Drive, Richland, Washington 99354, USA.

Related Concept Videos

Adsorption of Gases on Solids01:28

Adsorption of Gases on Solids

Adsorption is a process where molecules, known as the adsorbates, accumulate on a surface, which is referred to as the adsorbent or substrate. Occurring at the solid-gas interface, this phenomenon is crucial in various scientific and industrial contexts. The reverse of adsorption is desorption.Two types of adsorptions exist: physical (physisorption) and chemical (chemisorption). Physisorption involves gas molecules held to the solid's surface by relatively weak intermolecular van der Waals...
Chemical and Solubility Equilibria02:21

Chemical and Solubility Equilibria

The free energy change associated with dissolving a solute in a liter of solvent is called the free energy of a solution, ΔGsolution. The overall ΔGsolution is expressed as the balance of ΔGinteraction against the always-favorable free-energy of mixing, ΔGmixing. Solution formation is favorable if  ΔGsolution is less than zero, whereas it is unfavorable if ΔGsolution is greater than zero. In short, for a solution to form and complete dissolution to take place, the Gibbs energy change must be...
Adsorption Isotherms I01:29

Adsorption Isotherms I

Adsorption isotherms are mathematical models that describe how molecules in a gas or liquid phase interact with surfaces. Two of the most common isotherm models are the Langmuir and Freundlich isotherms, which relate to Type I monolayer chemisorption. The Langmuir model is based on four key assumptions:• Adsorption cannot exceed monolayer coverage.• All surface sites are equivalent.• Molecules adsorb only at vacant sites.• There are no interactions between adsorbed molecules.Consider the...
Solution Equilibrium and Saturation01:59

Solution Equilibrium and Saturation

Imagine adding a small amount of sugar to a glass of water, stirring until all the sugar has dissolved, and then adding a bit more. You can repeat this process until the sugar concentration of the solution reaches its natural limit, a limit determined primarily by the relative strengths of the solute-solute, solute-solvent, and solvent-solvent attractive forces. You can be certain that you have reached this limit because, no matter how long you stir the solution, undissolved sugar remains. The...
Colloidal precipitates01:09

Colloidal precipitates

The high insolubility of some precipitates can result in an unfavorable relative supersaturation. This can lead to colloidal particles with a large surface-to-mass ratio, where adsorption is promoted. For instance, in the precipitation of silver chloride, silver ions are adsorbed on the surface of the colloidal particles, forming a primary layer. This layer attracts ions of opposite charge (such as nitrate ions), forming a diffuse secondary layer of adsorbed ions. This electric double layer...
COP Coated Vesicles00:59

COP Coated Vesicles

Membrane-enclosed structures called vesicles transport proteins and lipids across the cell. The vesicles derive their cargo from the plasma membrane, Golgi, ER, or endosome. Coated vesicles are spherical, protein-coated carriers with a 50–100 nm diameter that mediate bidirectional transport between the ER and the Golgi. The distribution of proteins between the ER and Golgi complex is dynamic and is maintained by different coated vesicles. Their formation is driven by the assembly of different...