Biomechanical comparison of 4 fixation techniques of sacral pedicle screw in osteoporotic condition

An in vitro biomechanical cadaver study.

To compare the subsidence displacement after cyclic loading among 4 sacral pedicle screw fixations of bicortical, tricortical, standard polymethylmethacrylate (PMMA) augmentation, and sub-endplate PMMA augmentation in osteoporotic condition.

Implant failure caused by screw loosening is a clinical problem for lumbosacral fusions, especially in osteoporotic patients. To improve sacral screw anchoring strength, the main fixation techniques need to be evaluated biomechanically.

For this study, 11 fresh osteoporotic cadaver sacra were harvested and bone mineral density was measured with dual-energy radiograph absorptiometry. A 7 mm diameter monoaxial pedicle screw (S1) was randomly assigned by side (left vs. right) and placed bicortically or tricortically. The 2 screws, followed 2000 cyclic compression loading of 30 to 250 N, were removed. The screw tracts were filled up with PMMA, then, screws 5 mm shorter than the bicortical or tricortical fixation were reinserted (defined as standard and sub-endplate PMMA augmented sacral screw fixations, respectively). The PMMA augmented screws were then retested as before. Screw subsidence displacement after 2000 cyclic loading was measured and compared.

The average bone mineral density of 11 specimens was 0.71 g/cm, ranged from 0.65 to 0.78 g/cm. No significant difference of subsidence displacement was detected between tricortical and standard PMMA augmented screws (P>0.05), however, the 2 fixations exhibited markedly less subsidence than bicortical screw (P<0.05). Sub-endplate PMMA augmented screw showed the least subsidence among all the screws (P<0.05).

PMMA augmentation can increase the bonding strength of sacral screw-bone interface and the sub-endplate PMMA augmented sacral screw could obtain the highest stability among the 4 fixation techniques in osteoporotic condition.