Related Experiment Video

Updated: Jun 16, 2026

Measuring Spray Droplet Size from Agricultural Nozzles Using Laser Diffraction
08:14

Measuring Spray Droplet Size from Agricultural Nozzles Using Laser Diffraction

Published on: September 16, 2016

The determination of the sauter mean droplet diameter in fuel nozzle sprays

R H Dieck, R L Roberts

    Applied Optics
    |January 23, 2010
    PubMed

    More Related Videos

    Fabrication and Characterization of Thickness Mode Piezoelectric Devices for Atomization and Acoustofluidics10:39

    Fabrication and Characterization of Thickness Mode Piezoelectric Devices for Atomization and Acoustofluidics

    Published on: August 5, 2020

    A Cost-effective and Reliable Method to Predict Mechanical Stress in Single-use and Standard Pumps07:34

    A Cost-effective and Reliable Method to Predict Mechanical Stress in Single-use and Standard Pumps

    Published on: August 5, 2015

    Related Concept Videos

    Pipe Flowrate Measurement: Problem Solving01:28

    Pipe Flowrate Measurement: Problem Solving

    A spray tank system is engineered to uniformly distribute a pest-control liquid across plants by using a pressurized mechanism. The tank, pressurized to 150 kPa, holds the pesticide at a height of 0.80 meters. Liquid flows from the tank through a 1.9 meter pipe with a diameter of 0.015 meters, angled at 0.698 radians, ultimately reaching a 0.007 meter nozzle that sprays the pesticide. Accurate calculation of the system's flow rate is crucial to ensure uniform application, and this is achieved...
    Free Jet01:14

    Free Jet

    Free jets describe the flow of liquid exiting a reservoir through an opening into the atmosphere without resistance. The velocity (v) of the liquid jet is derived using Bernoulli's principle and expressed as:
    Design Example: Flow Through a Fire Extinguisher01:12

    Design Example: Flow Through a Fire Extinguisher

    A fire extinguisher that uses pressurized water relies on fluid dynamics principles to generate a high-velocity stream capable of suppressing flames. The water is stored at a much higher pressure inside the extinguisher than the surrounding atmosphere. This pressure difference forces the water to flow rapidly when the extinguisher is activated, and the behavior of the water as it exits the nozzle can be understood using fundamental equations of fluid dynamics.
    The key to understanding how the...
    Area of a Surface of Revolution01:29

    Area of a Surface of Revolution

    Surfaces of revolution are formed when a two-dimensional curve is rotated around an axis, producing a three-dimensional shape. This concept is used in engineering tasks like determining the surface area of a rocket nozzle, where precise calculations are critical for applying uniform heat-resistant coatings. When a curve is revolved about the x-axis, it sweeps out a continuous surface whose area must be calculated accurately to estimate material requirements.Approximating with Conical BandsTo...
    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...