Related Experiment Video

Updated: Jun 16, 2026

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping
14:58

Silicon Metal-oxide-semiconductor Quantum Dots for Single-electron Pumping

Published on: June 3, 2015

Vibration-electronic coupling in the quenching of electronically excited alkali atoms by diatomics

E R Fisher, G K Smith

    Applied Optics
    |January 30, 2010
    PubMed

    More Related Videos

    Construction and Characterization of External Cavity Diode Lasers for Atomic Physics09:10

    Construction and Characterization of External Cavity Diode Lasers for Atomic Physics

    Published on: April 24, 2014

    Cooling an Optically Trapped Ultracold Fermi Gas by Periodical Driving11:21

    Cooling an Optically Trapped Ultracold Fermi Gas by Periodical Driving

    Published on: March 30, 2017

    Related Concept Videos

    Alkali Metals03:06

    Alkali Metals

    Group 1 elements are soft and shiny metallic solids. They are malleable, ductile, and good conductors of heat and electricity. The melting points of the alkali metals are unusually low for metals and decrease going down the group, while the density increases going down the group with the exception of potassium (Table 1).
    Table 1: Properties of the alkali metals
    Double Resonance Techniques: Overview01:12

    Double Resonance Techniques: Overview

    Double resonance techniques in Nuclear Magnetic Resonance (NMR) spectroscopy involve the simultaneous application of two different frequencies or radiofrequency pulses to manipulate and observe two distinct nuclear spins. One important application of double resonance is spin decoupling, which selectively suppresses coupling with one type of nucleus while observing the NMR signal from another nucleus, simplifying the spectrum and enhancing resolution.
    Spin decoupling is usually achieved by...
    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
    ¹³C NMR: ¹H–¹³C Decoupling01:04

    ¹³C NMR: ¹H–¹³C Decoupling

    The probability of having two carbon-13 atoms next to each other is negligible because of the low natural abundance of carbon-13. Consequently, peak splitting due to carbon-carbon spin-spin coupling is not observed in spectra. However, protons up to three sigma bonds away split the carbon signal according to the n+1 rule, resulting in complicated spectra.
    A broadband decoupling technique is used to simplify these complex, sometimes overlapping, signals. Broadband decoupling relies on a...
    ¹H NMR: Long-Range Coupling01:27

    ¹H NMR: Long-Range Coupling

    The coupling interactions of nuclei across four or more bonds are usually weak, with J values less than 1 Hz. While these are usually not observed in spectra, the presence of multiple bonds along the coupling pathway can result in observable long-range coupling.
    In alkenes, spin information is communicated via σ–π overlap, as seen in allylic (four-bond) and homoallylic (five-bond) couplings. These coupling interactions are stronger when the σ bond is parallel to the alkene π orbitals.
    Spin–Spin Coupling: Two-Bond Coupling (Geminal Coupling)01:20

    Spin–Spin Coupling: Two-Bond Coupling (Geminal Coupling)

    Two NMR-active nuclei bonded to a central atom can be involved in geminal or two-bond coupling. Geminal coupling is commonly seen between diastereotopic protons in chiral molecules and unsymmetrical alkenes, among others.
    The central atom need not be NMR-active because its electrons are affected by the electron polarization of the spin-active atoms. However, spin information is transmitted less effectively than in one-bond coupling, and 2J values are usually weaker than 1J values. The energy of...