Related Experiment Video

Updated: Jun 16, 2026

Design, Fabrication, and Experimental Characterization of Plasmonic Photoconductive Terahertz Emitters
10:54

Design, Fabrication, and Experimental Characterization of Plasmonic Photoconductive Terahertz Emitters

Published on: July 8, 2013

Transmission Switching Characteristics of PLZT Shutters

M J Landry, A E McCarthy

    Applied Optics
    |February 4, 2010
    PubMed

    Related Concept Videos

    Switching of BJT01:22

    Switching of BJT

    Switching behavior in Bipolar Junction Transistors (BJTs) is a fundamental aspect utilized in various electronic circuits, particularly for digital logic applications like switches and amplifiers. In a typical switching circuit, a BJT alternates between cut-off and saturation modes, corresponding to the "off" and "on" states, respectively, thus behaving like an ideal switch.
    Cut-off Mode ("Off" State): In this state, both the emitter-base and collector-base junctions are reverse-biased. The...
    Lossy Lines and Overvoltages01:22

    Lossy Lines and Overvoltages

    Transmission-line series resistance and shunt conductance cause three primary effects: attenuation, distortion, and power losses.
    Attenuation
    When constant series resistance and shunt conductance are present, voltage and current equations are modified. The propagation constant indicates that voltage and current waves consist of both forward and backward traveling components. These waves attenuate as they propagate, with the attenuation factor related to the resistance and conductance. In a...
    Phase-lead and Phase-lag Controllers01:22

    Phase-lead and Phase-lag Controllers

    Understanding the working function of different types of controllers can be illustrated with practical analogies, such as adjusting a stereo's volume equalizer. Cranking up the bass involves a phase-lead controller, which functions as a high-pass filter, while increasing the treble uses a phase-lag controller, which acts as a low-pass filter. PD controllers, similar to high-pass filters, enhance the system's response to high-frequency components. PI controllers, akin to low-pass filters, manage...
    Control of Power Flow01:30

    Control of Power Flow

    There are several methods to control power flow in power systems:
    Time and frequency -Domain Interpretation of Phase-lag Control01:21

    Time and frequency -Domain Interpretation of Phase-lag Control

    Phase-lag controllers are widely used in control systems to improve stability and reduce steady-state errors. A dimmer switch controlling the brightness of a light bulb serves as a practical example of phase-lag control, gradually adjusting the bulb's brightness. Mathematically, phase-lag control or low-pass filtering is represented when the factor 'a' is less than 1.
    Phase-lag controllers do not place a pole at zero, but instead influence the steady-state error by amplifying any finite,...
    Power System Three-Phase Short Circuits01:21

    Power System Three-Phase Short Circuits

    Determining the subtransient fault current in a power system involves representing transformers by their leakage reactances, transmission lines by their equivalent series reactances, and synchronous machines as constant voltage sources behind their subtransient reactances. In this analysis, certain elements are excluded, such as winding resistances, series resistances, shunt admittances, delta-Y phase shifts, armature resistance, saturation, saliency, non-rotating impedance loads, and small...