Related Experiment Video

Updated: Jun 16, 2026

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing
10:42

Infrared Degenerate Four-wave Mixing with Upconversion Detection for Quantitative Gas Sensing

Published on: March 22, 2019

Quantitative Studies of HNO(3) Vapor Absorption in the 1700-2636-A Wavelength Region

S C Schmidt, A Goldman, F S Bonomo

    Applied Optics
    |February 4, 2010
    PubMed

    More Related Videos

    Automated, High-resolution Mobile Collection System for the Nitrogen Isotopic Analysis of NOx07:14

    Automated, High-resolution Mobile Collection System for the Nitrogen Isotopic Analysis of NOx

    Published on: December 20, 2016

    Characterization of Biological Absorption Spectra Spanning the Visible to the Short-Wave Infrared07:38

    Characterization of Biological Absorption Spectra Spanning the Visible to the Short-Wave Infrared

    Published on: January 10, 2025

    Related Concept Videos

    Volatilization01:10

    Volatilization

    Volatilization gravimetry is an analytical technique that measures the mass lost due to the volatilization of the substance. This technique is used to estimate the amount of volatile material in a sample. To perform this method, heat a known amount of the sample to a high temperature in a crucible or other suitable vessel. The volatile substance in the sample evaporates, and the vapor is completely expelled from the crucible either by heating the sample or bubbling a stream of inert gas through...
    Atomic Absorption Spectroscopy: Lab01:21

    Atomic Absorption Spectroscopy: Lab

    For AAS measurements, samples must be introduced as clear solutions, often requiring extensive preliminary treatment to dissolve materials like soils, animal tissues, and minerals. Common methods for sample preparation include treatment with hot mineral acids, wet ashing, combustion in closed containers, high-temperature ashing, or fusion with reagents.
     Solutions containing organic solvents, such as low-molecular-mass alcohols, esters, or ketones, enhance absorbances by increasing nebulizer...
    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations01:08

    IR Spectrum Peak Splitting: Symmetric vs Asymmetric Vibrations

    Identical bonds within a polyatomic group can stretch symmetrically (in-phase) or asymmetrically (out-of-phase). Similar to hydrogen bonding, these vibrations also influence the shape of the IR peak. Generally, asymmetric stretching frequencies are higher than symmetric stretching frequencies. For example, primary amines exhibit two distinct IR peaks between 3300–3500 cm−1 corresponding to the symmetric and asymmetric N-H stretching, while secondary amines exhibit a single stretching vibration...
    IR Frequency Region: X–H Stretching01:24

    IR Frequency Region: X–H Stretching

    In IR spectroscopy, signals produced by the X−H bonds (such as C−H, O−H, or N−H) can be observed in the frequency range of  2700–4000 cm–1. The C−H stretching vibration forms sharp bands in the region 2850–3000 cm–1. The presence of the O−H stretching vibration leads to the forming of an absorption band in the frequency range 3650–3200 cm−1. At the same time, N−H stretching can be confirmed by absorption bands in the 3500–3100 cm−1 range. Even though both O−H and N−H bonds vibrate at a similar...
    Atomic Absorption Spectroscopy: Atomization Methods01:25

    Atomic Absorption Spectroscopy: Atomization Methods

    Atomic Absorption Spectroscopy (AAS) atomizes samples through flame atomization or electrothermal atomization. Flame atomization typically involves a nebulizer and spray chamber assembly to combine the sample with a fuel–oxidant mixture, creating a fine aerosol mist that enters a burner. Typically, the fuel and oxidant are combined in an approximately stoichiometric ratio. However, for atoms that are easily oxidized, a fuel-rich mixture may be more advantageous. Only about 5% of the aerosol...
    Emission Spectra02:39

    Emission Spectra

    When solids, liquids, or condensed gases are heated sufficiently, they radiate some of the excess energy as light. Photons produced in this manner have a range of energies, and thereby produce a continuous spectrum in which an unbroken series of wavelengths is present.