Related Experiment Videos
Optical antenna gain. 3: The effect of secondary element support struts on transmitter gain
Applied Optics
|February 19, 2010
Abstract:
The effect of a secondary element spider support structure on optical antenna transmitter gain is analyzed. An expression describing the influence of the struts on the axial gain, in both the near and far fields, is derived as a function of the number of struts and their width. It is found that, for typical systems, the struts degrade the on-axis gain by less than 0.4 dB, and the first side-lobe level is not increased significantly. Contour plots have also been included to show the symmetry of the far-field distributions for three and four support members.
Related Concept Videos
01:15Gain
Gain and phase shift are properties of linear circuits that describe the effect a circuit has on a sinusoidal input voltage or current. The circuit's behavior that contains reactive elements will depend on the frequency of the input sinusoid. As a result, it is observed that the gain and phase shift will all be frequency functions.
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.
Gain:
Suppose Vin is the input and Vout is the output signal to a circuit.
01:20The Maximum Power Transfer Theorem
Consider a linear AC Thevenin equivalent circuit connected to a load impedance.
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
The load connected draws the current, and the circuit delivers the power to the load. The alternating current flowing through the load is determined using the rectangular form of voltages, currents, network impedance, and load impedance. The average power delivered to the load is obtained from the product of the square of current and load resistance.
01:24The Midpoint Formula
In coordinate geometry, determining the central point between two locations is common. This central point, or midpoint, lies exactly halfway along the line segment connecting two points in a two-dimensional space. It has applications in mathematics, physics, engineering, and various planning disciplines.Given two points labeled as A (x1, y1) and B (x2, y2) on a coordinate plane, a straight line segment can be plotted between them. The midpoint, labeled point M, divides this segment into two...
01:30Propagation Speed of Electromagnetic Waves
Electromagnetic waves are consistent with Ampere's law. Assuming there is no conduction current Ampere's law is given as:
01:16Cascaded Op Amps
Operational amplifiers (op-amps) are versatile electronic components that can be interconnected in a cascade - one after another in a linear sequence. This cascading is possible due to their infinite input resistance and zero output resistance, allowing them to maintain their input-output relationships even when connected in series.
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
In a cascaded system, each op-amp is referred to as a stage. The output of one stage drives the input of the subsequent stage. As the input signal passes through...
01:27Polar Coordinates: Problem Solving
Directional radiation patterns are central to antenna analysis, as they illustrate how signal strength varies with direction. These patterns are often modeled using polar plots, where the radial distance from the origin represents signal intensity at a given angle. A commonly used idealized form is the four-lobed rose curve, which captures the concept of directional beams in a simplified mathematical form.The four-lobed rose curve, described by r = cos(2θ), features four symmetric lobes, each...