Related Experiment Video
Updated: Jun 15, 2026

Preparation and High-temperature Anti-adhesion Behavior of a Slippery Surface on Stainless Steel
Published on: March 29, 2018
Utilized friction when entering and exiting a dry and wet bathtub
Gunter P Siegmund1, Jim Flynn, Daniel W Mang
1MEA Forensic Engineers & Scientists, 11-11151 Horseshoe Way, Richmond, BC, Canada V7A 4S5. gunter.siegmund@meaforensic.com
Abstract:
Bathtubs and showers are a common source of unintentional slips and falls. The goal of this study was to quantify the friction used by barefoot subjects entering and exiting a typical bathtub/shower enclosure under dry and wet conditions. Sixty subjects (30F, 30M) from three age groups (20-30 years, 40-50 years, 60-70 years) entered and exited a slip-resistant bathtub using six movement patterns (three entering and three exiting the tub) simulating actual use. Force plates installed in the tub floor and the slip-resistant deck outside the tub measured ground reaction forces, from which utilized friction and double support times were calculated. Overall, utilized friction varied from 0.102 to 0.442 (0.235+/-0.057) and was 0.058+/-0.040 lower in wet than dry conditions across all movement patterns (p<0.0001). During tub exiting movements, older subjects used less friction than young subjects (p<0.006). Utilized friction did not vary between genders (p>0.14). Double support times were longer in older subjects than in both young and middle-aged subjects for all movement patterns (p<0.0009) and longer under wet than dry conditions for all entry movements (p<0.0001). These data suggest that subjects regard the wet condition as more hazardous than the dry condition and adapt their utilized friction accordingly. These data also show that older subjects are more cautious than young subjects when confronted with the dual tasks of stepping over the tub's apron and transitioning to a surface perceived to be more slippery.
Related Concept Videos
Dry Friction
To illustrate this concept, imagine a wooden crate resting on a rough, non-uniform horizontal surface. When an external force is applied to...
Characteristics of Dry Friction
Before the wheelbarrow starts moving, the static frictional force acts tangentially to the contact surface, opposing the force that is about to induce the motion. This frictional force prevents the...
Types of Friction Problems
The first type of dry friction problem involves situations where there is no apparent impending motion.
Handwashing III: During the Procedure and Post-Procedure Steps
Frictional Force
Kinetic Friction

